On Tue, 12 Jan 1999, Thomas Sailer wrote:
> yes
Did you read my last message? I'll quote:
>From: Jorge Matias <[EMAIL PROTECTED]>
>To: Thomas Sailer <[EMAIL PROTECTED]>
>Cc: Linux-Ham Mailing List <[EMAIL PROTECTED]>
>Subject: Was: LINUX+BAYCOM Now: Prob with Baycom
>
>On Thu, 7 Jan 1999, Thomas Sailer wrote:
>
>> It's in 2.0.36 and recent 2.1.x, 2.2-pre
>
> Well, I have kernel 2.0.36 installed with baycom module installed. The
>problem is that I still can'tput the driver to work.
> Sometimes the driver starts and everything works well. But most of the
>times the driver is loaded it doesn't receives neither transmits.
>
> This is what "ifconfig bc0" shows:
>
>bc0 Link encap:AMPR AX.25 HWaddr CT2HBZ-4
> inet addr:44.158.28.30 Bcast:44.158.28.255 Mask:255.255.255.0
> UP BROADCAST RUNNING MTU:256 Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
> Collisions:0
> Interrupt:3 Base address:0x2f8
>
>
> Now, my starting script:
>
>setserial /dev/ttyS1 uart none # Desactivar COM1
>insmod hdlcdrv # Inserir module
>insmod baycom mode="ser12*" iobase=0x2f8 irq=3 # Inserir modulo de
>sethdlc -a -i bc0 txd 250 slot 100 ppersist 250 half
>ifconfig bc0 44.158.28.30 hw ax25 CT2HBZ-4 broadcast 44.158.28.255 \
>(this is written in the line above) netmask 255.255.255.0 mtu 256 up
>
> My computer is a Pentium/133 with built-in serial, parallel and IDE
>ports.
> FlexNet works well with this modem in the same port.
> And this Linux config sometimes work, sometimes don't.
>
> Do you have any idea of what could this be?
>
Regards,
Jorge Matias
- -- --- ------------------------------------------------- --- -- -
Computer Science Student at Instituto Superior Tecnico (Lisbon)
A3000/060 32Mb -[Ariadne][MFC III][CV64]- LinuxOS 2.0.33
QRZ: CT2HBZ - E-Mail: [EMAIL PROTECTED]
