On Fri, 2 Jul 1999, Masterson Pairetti wrote:
> Following AX25-HOWTO, i proceeded as follows:
>
> * setserial /dev/ttyS0 uart none /* to prevent resource sharing conflicts */
> * insmod hdlcdrv
> * insmod baycom_ser_hdx mode="ser12*" iobase=0x3f8 irq=4
> * sethdlc -i bcsf0 -p mode "ser12*" iobase 0x3f8 irq 4
> * sethdlc -i bcsf0 -a txd 200 slot 100 ppersist 40 half
> * ifconfig bcsf0 hw ax25 LW6DVO up
> * axparms -setcall bcsf0 LW6DVO-1
>
> everything ok by now....
>
> here's my /etc/ax25/axports
>
> # /etc/ax25/axports
> #
> vhf LW6DVO-1 1200 255 2 Puerto 2m
>
> But, when i do a, say, 'call vhf lu7dbl' i get the following error msg:
>
> axconfig: port vhf not active
> call: no AX.25 port data configured.
You need to give the bcsf0 interface an IP address. Even if you are not
going to run TCP/IP over it. If you don't have your own 44.x.x.x address
then just use something like 10.0.0.1.
--
Tomi Manninen Internet: [EMAIL PROTECTED]
OH2BNS AX.25: [EMAIL PROTECTED]
KP20ME Amprnet: [EMAIL PROTECTED]
