Hello "Rea", hello all,
> Today I wanted to migrate my packet-stuff from a pentium-75
running Win95 to
> a IBM PS/2 77 (486DX2) running Linux.
> Setting it up was no problem, but now the IBM-machine isn't receiving any
> frames... TX goed well, I think I configured the ports OK.
> I tried under DOS and have the same problem. I think it's hardware
> related... The baycom (TCM3105) is working fine on the Pentium.
>
> Any Idea's ??? I'm sorry if this is off-topic, but I wouldn't know where to
> go else...
I think it is a hardware problem. On some computers the BayCom
drivers have problems with the serial port (UART). The only thing
that helps reliably here is adding an old serial port card based on
the 8250 UART (or, in some cases, it also works with 16440).
Or do you have two serial ports using one interrupt? You should
avoid this since it leads to problems in most cases.
Cheers, 73
Gerd
