Allow the driver to work with dts support.

Based on initial patch submission from Peter Fox.

Tested on a imx7d-sdb board connected to a SHT15 board via Mikro Bus.

Signed-off-by: Marco Franchi <[email protected]>
---
 Documentation/devicetree/bindings/hwmon/sht15.txt | 25 ++++++++
 drivers/hwmon/sht15.c                             | 69 +++++++++++++++++++++--
 2 files changed, 90 insertions(+), 4 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/hwmon/sht15.txt

diff --git a/Documentation/devicetree/bindings/hwmon/sht15.txt 
b/Documentation/devicetree/bindings/hwmon/sht15.txt
new file mode 100644
index 0000000..6415f52
--- /dev/null
+++ b/Documentation/devicetree/bindings/hwmon/sht15.txt
@@ -0,0 +1,25 @@
+Sensirion SHT15 Humidity and Temperature Sensor
+
+Required properties:
+
+ - "compatible": must be "sensirion,sht15".
+ - "data-gpios": GPIO connected to the data line.
+ - "clk-gpios": GPIO connected to the clock line.
+ - "vcc-supply": regulator that drives the VCC pin.
+
+Optional properties:
+
+ - "checksum": boolean property that when present enables the CRC validation 
of the readings.
+ - "no-otp-reload": boolean property that when present indicates not to reload 
from OTP.
+ - "low-resolution": boolean property that when present indicates that the 
device operates in
+               low-resolution mode.
+Example:
+
+       temp_humid_sensor: sht15 {
+               pinctrl-names = "default";
+               pinctrl-0 = <&pinctrl_sensor>;
+               compatible = "sensirion,sht15";
+               clk-gpios = <&gpio4 12 0>;
+               data-gpios = <&gpio4 13 0>;
+               vcc-supply = <&reg_sht15>;
+       };
diff --git a/drivers/hwmon/sht15.c b/drivers/hwmon/sht15.c
index f16687c..608ac9e 100644
--- a/drivers/hwmon/sht15.c
+++ b/drivers/hwmon/sht15.c
@@ -34,6 +34,7 @@
 #include <linux/slab.h>
 #include <linux/atomic.h>
 #include <linux/bitrev.h>
+#include <linux/of_gpio.h>
 
 /* Commands */
 #define SHT15_MEASURE_TEMP             0x03
@@ -911,6 +912,59 @@ static int sht15_invalidate_voltage(struct notifier_block 
*nb,
        return NOTIFY_OK;
 }
 
+#ifdef CONFIG_OF
+static const struct of_device_id sht15_dt_match[] = {
+       { .compatible = "sensirion,sht15" },
+       { },
+};
+MODULE_DEVICE_TABLE(of, sht15_dt_match);
+
+/*
+ * This function returns 1 if pdev isn't a device instatiated by dt, 0 if it
+ * could successfully get all information from dt or a negative error number.
+ */
+static int sht15_probe_dt(struct sht15_data *data, struct platform_device 
*pdev)
+{
+       struct device_node *np = pdev->dev.of_node;
+       struct sht15_platform_data *pdata;
+
+       /* no device tree device */
+       if (!np)
+               return 1;
+
+       pdata = devm_kzalloc(&pdev->dev, sizeof(*pdata), GFP_KERNEL);
+       if (!pdata)
+               return -ENOMEM;
+
+       data->pdata = pdata;
+
+       data->pdata->gpio_data = of_get_named_gpio(np, "data-gpios", 0);
+       if (data->pdata->gpio_data < 0) {
+               dev_err(&pdev->dev, "data-gpios not found\n");
+               return data->pdata->gpio_data;
+       }
+
+       data->pdata->gpio_sck = of_get_named_gpio(np, "clk-gpios", 0);
+       if (data->pdata->gpio_sck < 0) {
+               dev_err(&pdev->dev, "clk-gpios not found\n");
+               return data->pdata->gpio_sck;
+       }
+
+       data->pdata->checksum = of_property_read_bool(np, "checksum");
+       data->pdata->no_otp_reload = of_property_read_bool(np, "no-otp-reload");
+       data->pdata->low_resolution = of_property_read_bool(np,
+                                       "low-resolution");
+
+       return 0;
+}
+#else
+static inline int sht15_probe_dt(struct sht15_data *data,
+                                       struct platform_device *pdev)
+{
+       return 1;
+}
+#endif
+
 static int sht15_probe(struct platform_device *pdev)
 {
        int ret;
@@ -928,11 +982,17 @@ static int sht15_probe(struct platform_device *pdev)
        data->dev = &pdev->dev;
        init_waitqueue_head(&data->wait_queue);
 
-       if (dev_get_platdata(&pdev->dev) == NULL) {
-               dev_err(&pdev->dev, "no platform data supplied\n");
-               return -EINVAL;
+       ret = sht15_probe_dt(data, pdev);
+       if (ret > 0) {
+               if (dev_get_platdata(&pdev->dev) == NULL) {
+                       dev_err(&pdev->dev, "no platform data supplied\n");
+                       return -EINVAL;
+               }
+               data->pdata = dev_get_platdata(&pdev->dev);
+       } else if (ret < 0) {
+               return ret;
        }
-       data->pdata = dev_get_platdata(&pdev->dev);
+
        data->supply_uv = data->pdata->supply_mv * 1000;
        if (data->pdata->checksum)
                data->checksumming = true;
@@ -1075,6 +1135,7 @@ MODULE_DEVICE_TABLE(platform, sht15_device_ids);
 static struct platform_driver sht15_driver = {
        .driver = {
                .name = "sht15",
+               .of_match_table = of_match_ptr(sht15_dt_match),
        },
        .probe = sht15_probe,
        .remove = sht15_remove,
-- 
2.7.4

--
To unsubscribe from this list: send the line "unsubscribe linux-hwmon" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to