On Tuesday 27 November 2018 23:06:37 Michele Sorcinelli wrote:
> Allow the module to be loaded on Dell XPS 9570, without having to use
> the "force=1" option. The module loads without problems, and reports
> correct fan values:
>
> $ time cat /proc/i8k
> 1.0 1.5 -1 35 0 0 0 0 -1 -22
> cat /proc/i8k 0.00s user 0.00s system 7% cpu 0.033 total
Hi! This interface is deprecated and should not be used in new project
or software...
> However, the call may freeze the kernel for a very small time due to
> code running in the SSM layer. This is a known issue with the driver, and
> can be reproduced with other supported models. Average execution
> time is 33 ms.
>
> The command line tools from i8kutils can properly set the fan speed,
> although the firmware will override it, unless automatic fan
> control is disabled with the proper SSM call.
i8kutils uses /proc/i8k too.
Can you check standard hwmon interface via lm-sensors / sensors command
is also working correctly? If you do not have sensors command you can
also look into /sys/class/hwmon/
> Average fans speed (when firwmare automatic control is off):
>
> STATE -> RPM
> 0 0 -> 0 0
> 1 1 -> 2500 2500
> 2 2 -> 5100 5100
> 3 3 -> same as 2 2
> ---
> drivers/hwmon/dell-smm-hwmon.c | 7 +++++++
> 1 file changed, 7 insertions(+)
>
> diff --git a/drivers/hwmon/dell-smm-hwmon.c b/drivers/hwmon/dell-smm-hwmon.c
> index 9d3ef879d..367a8a617 100644
> --- a/drivers/hwmon/dell-smm-hwmon.c
> +++ b/drivers/hwmon/dell-smm-hwmon.c
> @@ -1017,6 +1017,13 @@ static const struct dmi_system_id i8k_dmi_table[]
> __initconst = {
> DMI_MATCH(DMI_PRODUCT_NAME, "XPS 15 9560"),
> },
> },
> + {
> + .ident = "Dell XPS 15 9570",
> + .matches = {
> + DMI_MATCH(DMI_SYS_VENDOR, "Dell Inc."),
> + DMI_MATCH(DMI_PRODUCT_NAME, "XPS 15 9570"),
> + },
> + },
> { }
> };
>
--
Pali Rohár
[email protected]
