The reset functions sets writes the slave address even in not slave mode. I don't see any reason in writting it if slave mode is not enabled. Ben Dooks was conserned about making this change make it unavable on X86 where it is not available.
Cc: [email protected] Signed-off-by: Sebastian Andrzej Siewior <[email protected]> Signed-off-by: Dirk Brandewie <[email protected]> --- drivers/i2c/busses/i2c-pxa.c | 2 ++ 1 files changed, 2 insertions(+), 0 deletions(-) diff --git a/drivers/i2c/busses/i2c-pxa.c b/drivers/i2c/busses/i2c-pxa.c index f4c19a9..aadf9d2 100644 --- a/drivers/i2c/busses/i2c-pxa.c +++ b/drivers/i2c/busses/i2c-pxa.c @@ -418,7 +418,9 @@ static void i2c_pxa_reset(struct pxa_i2c *i2c) writel(I2C_ISR_INIT, _ISR(i2c)); writel(readl(_ICR(i2c)) & ~ICR_UR, _ICR(i2c)); +#ifndef CONFIG_X86 writel(i2c->slave_addr, _ISAR(i2c)); +#endif /* set control register values */ writel(I2C_ICR_INIT | (i2c->fast_mode ? ICR_FM : 0), _ICR(i2c)); -- 1.7.3.2 -- To unsubscribe from this list: send the line "unsubscribe linux-i2c" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
