Hi, On Tue, Nov 08, 2011 at 11:49:24AM +0100, Nikolaus Voss wrote: > Signed-off-by: Nikolaus Voss <[email protected]> > --- > drivers/i2c/busses/i2c-at91.c | 327 > ----------------------------------------- > 1 files changed, 0 insertions(+), 327 deletions(-) > delete mode 100644 drivers/i2c/busses/i2c-at91.c > > diff --git a/drivers/i2c/busses/i2c-at91.c b/drivers/i2c/busses/i2c-at91.c > deleted file mode 100644 > index 305c075..0000000 > --- a/drivers/i2c/busses/i2c-at91.c > +++ /dev/null > @@ -1,327 +0,0 @@ > -/* > - i2c Support for Atmel's AT91 Two-Wire Interface (TWI) > - > - Copyright (C) 2004 Rick Bronson > - Converted to 2.6 by Andrew Victor <[email protected]> > - > - Borrowed heavily from original work by: > - Copyright (C) 2000 Philip Edelbrock <[email protected]> > - > - This program is free software; you can redistribute it and/or modify > - it under the terms of the GNU General Public License as published by > - the Free Software Foundation; either version 2 of the License, or > - (at your option) any later version. > -*/ > - > -#include <linux/module.h> > -#include <linux/kernel.h> > -#include <linux/err.h> > -#include <linux/slab.h> > -#include <linux/types.h> > -#include <linux/delay.h> > -#include <linux/i2c.h> > -#include <linux/init.h> > -#include <linux/clk.h> > -#include <linux/platform_device.h> > -#include <linux/io.h> > - > -#include <mach/at91_twi.h> > -#include <mach/board.h> > -#include <mach/cpu.h> > - > -#define TWI_CLOCK 100000 /* Hz. max 400 Kbits/sec */ > - > - > -static struct clk *twi_clk; > -static void __iomem *twi_base; > - > -#define at91_twi_read(reg) __raw_readl(twi_base + (reg)) > -#define at91_twi_write(reg, val) __raw_writel((val), twi_base + (reg)) > - > - > -/* > - * Initialize the TWI hardware registers. > - */ > -static void __devinit at91_twi_hwinit(void) > -{ > - unsigned long cdiv, ckdiv; > - > - at91_twi_write(AT91_TWI_IDR, 0xffffffff); /* Disable all > interrupts */ > - at91_twi_write(AT91_TWI_CR, AT91_TWI_SWRST); /* Reset peripheral */ > - at91_twi_write(AT91_TWI_CR, AT91_TWI_MSEN); /* Set Master mode */ > - > - /* Calcuate clock dividers */ > - cdiv = (clk_get_rate(twi_clk) / (2 * TWI_CLOCK)) - 3; > - cdiv = cdiv + 1; /* round up */ > - ckdiv = 0; > - while (cdiv > 255) { > - ckdiv++; > - cdiv = cdiv >> 1; > - } > - > - if (cpu_is_at91rm9200()) { /* AT91RM9200 Errata > #22 */ > - if (ckdiv > 5) { > - printk(KERN_ERR "AT91 I2C: Invalid TWI_CLOCK value!\n"); > - ckdiv = 5; > - } > - } > - > - at91_twi_write(AT91_TWI_CWGR, (ckdiv << 16) | (cdiv << 8) | cdiv); > -} > - > -/* > - * Poll the i2c status register until the specified bit is set. > - * Returns 0 if timed out (100 msec). > - */ > -static short at91_poll_status(unsigned long bit) > -{ > - int loop_cntr = 10000; > - > - do { > - udelay(10); > - } while (!(at91_twi_read(AT91_TWI_SR) & bit) && (--loop_cntr > 0)); > - > - return (loop_cntr > 0); > -} > - > -static int xfer_read(struct i2c_adapter *adap, unsigned char *buf, int > length) > -{ > - /* Send Start */ > - at91_twi_write(AT91_TWI_CR, AT91_TWI_START); > - > - /* Read data */ > - while (length--) { > - if (!length) /* need to send Stop before reading last byte */ > - at91_twi_write(AT91_TWI_CR, AT91_TWI_STOP); > - if (!at91_poll_status(AT91_TWI_RXRDY)) { > - dev_dbg(&adap->dev, "RXRDY timeout\n"); > - return -ETIMEDOUT; > - } > - *buf++ = (at91_twi_read(AT91_TWI_RHR) & 0xff); > - } > - > - return 0; > -} > - > -static int xfer_write(struct i2c_adapter *adap, unsigned char *buf, int > length) > -{ > - /* Load first byte into transmitter */ > - at91_twi_write(AT91_TWI_THR, *buf++); > - > - /* Send Start */ > - at91_twi_write(AT91_TWI_CR, AT91_TWI_START); > - > - do { > - if (!at91_poll_status(AT91_TWI_TXRDY)) { > - dev_dbg(&adap->dev, "TXRDY timeout\n"); > - return -ETIMEDOUT; > - } > - > - length--; /* byte was transmitted */ > - > - if (length > 0) /* more data to send? */ > - at91_twi_write(AT91_TWI_THR, *buf++); > - } while (length); > - > - /* Send Stop */ > - at91_twi_write(AT91_TWI_CR, AT91_TWI_STOP); > - > - return 0; > -} > - > -/* > - * Generic i2c master transfer entrypoint. > - * > - * Note: We do not use Atmel's feature of storing the "internal device > address". > - * Instead the "internal device address" has to be written using a separate > - * i2c message. > - * > http://lists.arm.linux.org.uk/pipermail/linux-arm-kernel/2004-September/024411.html > - */ > -static int at91_xfer(struct i2c_adapter *adap, struct i2c_msg *pmsg, int num) > -{ > - int i, ret; > - > - dev_dbg(&adap->dev, "at91_xfer: processing %d messages:\n", num); > - > - for (i = 0; i < num; i++) { > - dev_dbg(&adap->dev, " #%d: %sing %d byte%s %s 0x%02x\n", i, > - pmsg->flags & I2C_M_RD ? "read" : "writ", > - pmsg->len, pmsg->len > 1 ? "s" : "", > - pmsg->flags & I2C_M_RD ? "from" : "to", pmsg->addr); > - > - at91_twi_write(AT91_TWI_MMR, (pmsg->addr << 16) > - | ((pmsg->flags & I2C_M_RD) ? AT91_TWI_MREAD : 0)); > - > - if (pmsg->len && pmsg->buf) { /* sanity check */ > - if (pmsg->flags & I2C_M_RD) > - ret = xfer_read(adap, pmsg->buf, pmsg->len); > - else > - ret = xfer_write(adap, pmsg->buf, pmsg->len); > - > - if (ret) > - return ret; > - > - /* Wait until transfer is finished */ > - if (!at91_poll_status(AT91_TWI_TXCOMP)) { > - dev_dbg(&adap->dev, "TXCOMP timeout\n"); > - return -ETIMEDOUT; > - } > - } > - dev_dbg(&adap->dev, "transfer complete\n"); > - pmsg++; /* next message */ > - } > - return i; > -} > - > -/* > - * Return list of supported functionality. > - */ > -static u32 at91_func(struct i2c_adapter *adapter) > -{ > - return I2C_FUNC_I2C | I2C_FUNC_SMBUS_EMUL; > -} > - > -static struct i2c_algorithm at91_algorithm = { > - .master_xfer = at91_xfer, > - .functionality = at91_func, > -}; > - > -/* > - * Main initialization routine. > - */ > -static int __devinit at91_i2c_probe(struct platform_device *pdev) > -{ > - struct i2c_adapter *adapter; > - struct resource *res; > - int rc; > - > - res = platform_get_resource(pdev, IORESOURCE_MEM, 0); > - if (!res) > - return -ENXIO; > - > - if (!request_mem_region(res->start, resource_size(res), "at91_i2c")) > - return -EBUSY; > - > - twi_base = ioremap(res->start, resource_size(res)); > - if (!twi_base) { > - rc = -ENOMEM; > - goto fail0; > - } > - > - twi_clk = clk_get(NULL, "twi_clk"); > - if (IS_ERR(twi_clk)) { > - dev_err(&pdev->dev, "no clock defined\n"); > - rc = -ENODEV; > - goto fail1; > - } > - > - adapter = kzalloc(sizeof(struct i2c_adapter), GFP_KERNEL); > - if (adapter == NULL) { > - dev_err(&pdev->dev, "can't allocate inteface!\n"); > - rc = -ENOMEM; > - goto fail2; > - } > - snprintf(adapter->name, sizeof(adapter->name), "AT91"); > - adapter->algo = &at91_algorithm; > - adapter->class = I2C_CLASS_HWMON; > - adapter->dev.parent = &pdev->dev; > - /* adapter->id == 0 ... only one TWI controller for now */ > - > - platform_set_drvdata(pdev, adapter); > - > - clk_enable(twi_clk); /* enable peripheral clock */ > - at91_twi_hwinit(); /* initialize TWI controller */ > - > - rc = i2c_add_numbered_adapter(adapter); > - if (rc) { > - dev_err(&pdev->dev, "Adapter %s registration failed\n", > - adapter->name); > - goto fail3; > - } > - > - dev_info(&pdev->dev, "AT91 i2c bus driver.\n"); > - return 0; > - > -fail3: > - platform_set_drvdata(pdev, NULL); > - kfree(adapter); > - clk_disable(twi_clk); > -fail2: > - clk_put(twi_clk); > -fail1: > - iounmap(twi_base); > -fail0: > - release_mem_region(res->start, resource_size(res)); > - > - return rc; > -} > - > -static int __devexit at91_i2c_remove(struct platform_device *pdev) > -{ > - struct i2c_adapter *adapter = platform_get_drvdata(pdev); > - struct resource *res; > - int rc; > - > - rc = i2c_del_adapter(adapter); > - platform_set_drvdata(pdev, NULL); > - > - res = platform_get_resource(pdev, IORESOURCE_MEM, 0); > - iounmap(twi_base); > - release_mem_region(res->start, resource_size(res)); > - > - clk_disable(twi_clk); /* disable peripheral clock */ > - clk_put(twi_clk); > - > - return rc; > -} > - > -#ifdef CONFIG_PM > - > -/* NOTE: could save a few mA by keeping clock off outside of at91_xfer... */ > - > -static int at91_i2c_suspend(struct platform_device *pdev, pm_message_t mesg) > -{ > - clk_disable(twi_clk); > - return 0; > -} > - > -static int at91_i2c_resume(struct platform_device *pdev) > -{ > - return clk_enable(twi_clk); > -} > - > -#else > -#define at91_i2c_suspend NULL > -#define at91_i2c_resume NULL > -#endif > - > -/* work with "modprobe at91_i2c" from hotplugging or coldplugging */ > -MODULE_ALIAS("platform:at91_i2c"); > - > -static struct platform_driver at91_i2c_driver = { > - .probe = at91_i2c_probe, > - .remove = __devexit_p(at91_i2c_remove), > - .suspend = at91_i2c_suspend, > - .resume = at91_i2c_resume, > - .driver = { > - .name = "at91_i2c", > - .owner = THIS_MODULE, > - }, > -}; > - > -static int __init at91_i2c_init(void) > -{ > - return platform_driver_register(&at91_i2c_driver); > -} > - > -static void __exit at91_i2c_exit(void) > -{ > - platform_driver_unregister(&at91_i2c_driver); > -} > - > -module_init(at91_i2c_init); > -module_exit(at91_i2c_exit); > - > -MODULE_AUTHOR("Rick Bronson"); > -MODULE_DESCRIPTION("I2C (TWI) driver for Atmel AT91"); > -MODULE_LICENSE("GPL");
after this patch you could be breaking tree compilation. -- balbi
signature.asc
Description: Digital signature
