On Fri, Oct 24, 2014 at 02:50:17PM +0800, Wenyou Yang wrote: > Amend the i2c at91 pin controller to optionally take a pin control > handle and set the state of the pins to: > > - "default" on boot, resume and before performing an transfer > - "sleep" on suspend() > > This should make it possible to optimize energy usage for the pins > both for the suspend/resume cycle > > Signed-off-by: Wenyou Yang <[email protected]> > --- > drivers/i2c/busses/i2c-at91.c | 7 +++++++ > 1 file changed, 7 insertions(+) > > diff --git a/drivers/i2c/busses/i2c-at91.c b/drivers/i2c/busses/i2c-at91.c > index 6a84a2a..290caf1 100644 > --- a/drivers/i2c/busses/i2c-at91.c > +++ b/drivers/i2c/busses/i2c-at91.c > @@ -32,6 +32,7 @@ > #include <linux/slab.h> > #include <linux/platform_data/dma-atmel.h> > #include <linux/pm_runtime.h> > +#include <linux/pinctrl/consumer.h> > > #define DEFAULT_TWI_CLK_HZ 100000 /* max 400 Kbits/s */ > #define AT91_I2C_TIMEOUT msecs_to_jiffies(100) /* transfer timeout */ > @@ -747,6 +748,8 @@ static int at91_twi_probe(struct platform_device *pdev) > u32 phy_addr; > u32 bus_clk_rate; > > + pinctrl_pm_select_default_state(&pdev->dev); > +
Do we really need this in probe? Isn't that default? I'm not sure,
though...
> dev = devm_kzalloc(&pdev->dev, sizeof(*dev), GFP_KERNEL);
> if (!dev)
> return -ENOMEM;
> @@ -851,6 +854,8 @@ static int at91_twi_runtime_suspend(struct device *dev)
>
> clk_disable_unprepare(twi_dev->clk);
>
> + pinctrl_pm_select_sleep_state(dev);
> +
> return 0;
> }
>
> @@ -858,6 +863,8 @@ static int at91_twi_runtime_resume(struct device *dev)
> {
> struct at91_twi_dev *twi_dev = dev_get_drvdata(dev);
>
> + pinctrl_pm_select_default_state(dev);
> +
> return clk_prepare_enable(twi_dev->clk);
> }
>
> --
> 1.7.9.5
>
signature.asc
Description: Digital signature
