From: Wolfram Sang <wsa+rene...@sang-engineering.com>

Also, sort the properties alphabetically and make indentation
consistent. Wording largely taken from i2c-rk3x.txt, thanks guys!

Only "i2c-scl-internal-delay-ns" is new, the rest is used by two drivers
already and was documented in their driver binding documentation.

Signed-off-by: Wolfram Sang <wsa+rene...@sang-engineering.com>
---
 Documentation/devicetree/bindings/i2c/i2c.txt | 31 ++++++++++++++++++++++-----
 1 file changed, 26 insertions(+), 5 deletions(-)

diff --git a/Documentation/devicetree/bindings/i2c/i2c.txt 
b/Documentation/devicetree/bindings/i2c/i2c.txt
index 8a99150ac3a7fd..a00219f5ee0733 100644
--- a/Documentation/devicetree/bindings/i2c/i2c.txt
+++ b/Documentation/devicetree/bindings/i2c/i2c.txt
@@ -29,12 +29,33 @@ Optional properties
 These properties may not be supported by all drivers. However, if a driver
 wants to support one of the below features, it should adapt the bindings below.
 
-- clock-frequency      - frequency of bus clock in Hz.
-- wakeup-source                - device can be used as a wakeup source.
+- clock-frequency
+       frequency of bus clock in Hz.
 
-- interrupts           - interrupts used by the device.
-- interrupt-names      - "irq" and "wakeup" names are recognized by I2C core,
-                         other names are left to individual drivers.
+- i2c-scl-falling-time-ns
+       Number of nanoseconds the SCL signal takes to fall; t(f) in the I2C
+       specification.
+
+- i2c-scl-internal-delay-ns
+       Number of nanoseconds the IP core additionally needs to setup SCL.
+
+- i2c-scl-rising-time-ns
+       Number of nanoseconds the SCL signal takes to rise; t(r) in the I2C
+       specification.
+
+- i2c-sda-falling-time-ns
+       Number of nanoseconds the SDA signal takes to fall; t(f) in the I2C
+       specification.
+
+- interrupts
+       interrupts used by the device.
+
+- interrupt-names
+       "irq" and "wakeup" names are recognized by I2C core, other names are
+       left to individual drivers.
+
+- wakeup-source
+       device can be used as a wakeup source.
 
 Binding may contain optional "interrupts" property, describing interrupts
 used by the device. I2C core will assign "irq" interrupt (or the very first
-- 
2.1.4

--
To unsubscribe from this list: send the line "unsubscribe linux-i2c" in
the body of a message to majord...@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to