On 10/30/07, Michael Tokarev <[EMAIL PROTECTED]> wrote: > By the way, did you forget to remove a jumper on the drive > (the only jumper installed by default) that limits drive > usage to SATAI? ... > ..etc. Try again without the jumper? Note that NCQ is NOT supported > in SATAI mode, or there were some pre-standard implementations of it. > In SATAII, NCQ is standard (well... more or less anyway ;)
Huh? To my knowledge, the jumper should only limit the bus rate to 1.5Gbit/s, for compatibility with one or more chipsets. It shouldn't affect the command set supported by the device. - To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html
