Hello!
I'm running 2.6.24-rc7 with an Addonics AD4CFPRJ Quad-CF PCI Controller
(http://www.addonics.com/products/flash_memory_reader/ad4cfprj.asp) using
Silicon Image PCI0680 chipset which is connected direct (no cables) with 2
Compact-Flash Cards.
In configured
CONFIG_ATA=y
CONFIG_PATA_SIL680=y
and the controller is correclty found, but it complains about 40-wire cables,
but I'm not using any cables
at all.
Is there a solution to disable this check or to correct this?
Regards
Tobias
dmesg reports
[ 32.577206] pata_sil680 0000:03:04.0: version 0.4.8
[ 32.577230] sil680: 133MHz clock.
[ 32.577302] ACPI: PCI Interrupt 0000:03:04.0[A] -> GSI 16 (level, low) ->
IRQ 16
[ 32.577986] PCI: Setting latency timer of device 0000:03:04.0 to 64
[ 32.578062] scsi4 : pata_sil680
[ 32.578232] scsi5 : pata_sil680
[ 32.578337] ata5: PATA max UDMA/133 irq 16
[ 32.578399] ata6: PATA max UDMA/133 irq 16
[ 32.732289] ata5.00: ATA-4: SanDisk SDCFX4-8192, HDX 4.20, max UDMA/66
[ 32.732353] ata5.00: 16007040 sectors, multi 0: LBA
[ 32.732422] ata5.00: limited to UDMA/33 due to 40-wire cable
[ 32.733155] ata5.00: configured for UDMA/33
[ 32.892034] ata6.00: ATA-4: SanDisk SDCFX3-2048, HDX 4.08, max MWDMA2
[ 32.892099] ata6.00: 4001760 sectors, multi 0: LBA
[ 32.911705] ata6.00: configured for MWDMA2
[ 32.911856] scsi 4:0:0:0: Direct-Access ATA SanDisk SDCFX4-8 HDX
PQ: 0 ANSI: 5
[ 32.912062] sd 4:0:0:0: [sdc] 16007040 512-byte hardware sectors (8196 MB)
[ 32.912135] sd 4:0:0:0: [sdc] Write Protect is off
[ 32.912198] sd 4:0:0:0: [sdc] Mode Sense: 00 3a 00 00
[ 32.912215] sd 4:0:0:0: [sdc] Write cache: disabled, read cache: enabled,
doesn't support DPO or FUA
[ 32.912357] sd 4:0:0:0: [sdc] 16007040 512-byte hardware sectors (8196 MB)
[ 32.912429] sd 4:0:0:0: [sdc] Write Protect is off
[ 32.912492] sd 4:0:0:0: [sdc] Mode Sense: 00 3a 00 00
[ 32.912508] sd 4:0:0:0: [sdc] Write cache: disabled, read cache: enabled,
doesn't support DPO or FUA
[ 32.912604] sdc: sdc1 sdc2
[ 32.913353] sd 4:0:0:0: [sdc] Attached SCSI disk
[ 32.913554] scsi 5:0:0:0: Direct-Access ATA SanDisk SDCFX3-2 HDX
PQ: 0 ANSI: 5
[ 32.913746] sd 5:0:0:0: [sdd] 4001760 512-byte hardware sectors (2049 MB)
[ 32.913819] sd 5:0:0:0: [sdd] Write Protect is off
[ 32.913882] sd 5:0:0:0: [sdd] Mode Sense: 00 3a 00 00
[ 32.913898] sd 5:0:0:0: [sdd] Write cache: disabled, read cache: enabled,
doesn't support DPO or FUA
[ 32.914026] sd 5:0:0:0: [sdd] 4001760 512-byte hardware sectors (2049 MB)
[ 32.914099] sd 5:0:0:0: [sdd] Write Protect is off
[ 32.914161] sd 5:0:0:0: [sdd] Mode Sense: 00 3a 00 00
[ 32.914176] sd 5:0:0:0: [sdd] Write cache: disabled, read cache: enabled,
doesn't support DPO or FUA
[ 32.914273] sdd: sdd1
[ 32.915200] sd 5:0:0:0: [sdd] Attached SCSI dis
lspci -v
03:04.0 RAID bus controller: Silicon Image, Inc. PCI0680 Ultra ATA-133 Host
Controller (rev 02)
Subsystem: Silicon Image, Inc. Winic W-680 (Silicon Image 680 based)
Flags: bus master, medium devsel, latency 64, IRQ 16
I/O ports at df00 [size=8]
I/O ports at de00 [size=4]
I/O ports at dd00 [size=8]
I/O ports at dc00 [size=4]
I/O ports at db00 [size=16]
Memory at fdcff000 (32-bit, non-prefetchable) [size=256]
[virtual] Expansion ROM at fdb00000 [disabled] [size=512K]
Capabilities: [60] Power Management version 2
Kernel driver in use: pata_sil680
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
