[EMAIL PROTECTED] wrote:
I replaced 80 wire flat cable with another 40 wire cable.
In this way I have no errors but now UDMA mode is set to 2 value.
I'm sure that MOTHERBOARD supports UDMA ATA/33/66/100 BUS IDE ports.
What do you think ?
[sticking nose in...]
In that case, it could be one of...
#1 faulty cable, try another 80c cable
#2 only one device gets attached to the cable but it's using the
middle connector. You need to use the connector at the end of cable
when you connect only one device. (I think it became a requirement w/
newer transfer modes. No? still recommendation?)
#3 faulty IDE controller (or faulty traces from the controller to cable)
#4 faulty drive
My bet is on #1 or #2.
--
tejun
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
