Yes, with another hard drive, which is error-free everything works just fine, with one exception:
libata version 1.11 loaded. sata_promise version 1.01 PCI: Found IRQ 5 for device 0000:01:0a.0 ata1: SATA max UDMA/133 cmd 0xCC802200 ctl 0xCC802238 bmdma 0x0 irq 5 ata2: SATA max UDMA/133 cmd 0xCC802280 ctl 0xCC8022B8 bmdma 0x0 irq 5 ata3: PATA max UDMA/133 cmd 0xCC802300 ctl 0xCC802338 bmdma 0x0 irq 5 ata4: PATA max UDMA/133 cmd 0xCC802380 ctl 0xCC8023B8 bmdma 0x0 irq 5 ata1: dev 0 cfg 49:0f00 82:346b 83:5b01 84:4003 85:3469 86:1a01 87:4003 88:407f ata1: dev 0 ATA-5, max UDMA/133, 40132503 sectors: LBA ata1: dev 0 configured for UDMA/133 scsi0 : sata_promise ATA: abnormal status 0x8 on port 0xCC80229C ata2: disabling port scsi1 : sata_promise ATA: abnormal status 0x8 on port 0xCC80231C ata3: disabling port scsi2 : sata_promise ATA: abnormal status 0x8 on port 0xCC80239C ata4: disabling port scsi3 : sata_promise Vendor: ATA Model: MAXTOR 6L020J1 Rev: A93. Type: Direct-Access ANSI SCSI revision: 05 SCSI device sda: 40132503 512-byte hdwr sectors (20548 MB) SCSI device sda: drive cache: write back SCSI device sda: 40132503 512-byte hdwr sectors (20548 MB) SCSI device sda: drive cache: write back /dev/scsi/host0/bus0/target0/lun0: unknown partition table Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0 As you can see, only one hard drive is connected to my TX4000, and because I disabled sata check I get abnormal status on another ports. But my hard drive works just fine! I'm looking forward to attach another hard drive and create RAID in TX4000 BIOS. I wonder, will sata_promise detect two disks on two ports, or just one thru BIOS? - To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html
