ahci_save_initial_config() is responsible for reading, screening the
host CAP register and storing the modified result into hpriv->cap for
the rest of the driver. Move ATA_FLAG_NO_NCQ handling into
ahci_save_initial_config(). It's more consistent this way and the
rest of the driver can always refer to hpriv->cap to determine
configured capability.
Signed-off-by: Tejun Heo <[EMAIL PROTECTED]>
---
drivers/ata/ahci.c | 10 ++++++++--
1 files changed, 8 insertions(+), 2 deletions(-)
diff --git a/drivers/ata/ahci.c b/drivers/ata/ahci.c
index 0e001ad..0555db5 100644
--- a/drivers/ata/ahci.c
+++ b/drivers/ata/ahci.c
@@ -527,13 +527,19 @@ static void ahci_save_initial_config(struct pci_dev *pdev,
hpriv->saved_cap = cap = readl(mmio + HOST_CAP);
hpriv->saved_port_map = port_map = readl(mmio + HOST_PORTS_IMPL);
- /* some chips lie about 64bit support */
+ /* some chips lie about their capabilities, bust them */
if ((cap & HOST_CAP_64) && (pi->flags & AHCI_FLAG_32BIT_ONLY)) {
dev_printk(KERN_INFO, &pdev->dev,
"controller can't do 64bit DMA, forcing 32bit\n");
cap &= ~HOST_CAP_64;
}
+ if ((cap & HOST_CAP_NCQ) && (pi->flags & AHCI_FLAG_NO_NCQ)) {
+ dev_printk(KERN_INFO, &pdev->dev,
+ "controller can't do NCQ, turning off CAP_NCQ\n");
+ cap &= ~HOST_CAP_NCQ;
+ }
+
/* fixup zero port_map */
if (!port_map) {
port_map = (1 << ahci_nr_ports(cap)) - 1;
@@ -1752,7 +1758,7 @@ static int ahci_init_one(struct pci_dev *pdev, const
struct pci_device_id *ent)
ahci_save_initial_config(pdev, &pi, hpriv);
/* prepare host */
- if (!(pi.flags & AHCI_FLAG_NO_NCQ) && (hpriv->cap & HOST_CAP_NCQ))
+ if (hpriv->cap & HOST_CAP_NCQ)
pi.flags |= ATA_FLAG_NCQ;
host = ata_host_alloc_pinfo(&pdev->dev, ppi, fls(hpriv->port_map));
--
1.5.0.3
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
