On Sun, 2007-07-22 at 20:32 +0200, Bartlomiej Zolnierkiewicz wrote:
> Don't check for good device status before executing the command in
> pmac_ide_do_setfeature() (ide_config_drive_speed() doesn't do this).
>
> It is a job of upper layers to guarantee that the device is ready to
> accept new command before we get here.
I had issues in those areas ... I'd like to keep a warning at least or
something in there for now.
Ben.
> Cc: Benjamin Herrenschmidt <[EMAIL PROTECTED]>
> Signed-off-by: Bartlomiej Zolnierkiewicz <[EMAIL PROTECTED]>
> ---
> drivers/ide/ppc/pmac.c | 12 +-----------
> 1 file changed, 1 insertion(+), 11 deletions(-)
>
> Index: b/drivers/ide/ppc/pmac.c
> ===================================================================
> --- a/drivers/ide/ppc/pmac.c
> +++ b/drivers/ide/ppc/pmac.c
> @@ -547,16 +547,6 @@ pmac_ide_do_setfeature(ide_drive_t *driv
> SELECT_DRIVE(drive);
> SELECT_MASK(drive, 0);
> udelay(1);
> - /* Get rid of pending error state */
> - (void) hwif->INB(IDE_STATUS_REG);
> - /* Timeout bumped for some powerbooks */
> - if (wait_for_ready(drive, 2000)) {
> - /* Timeout bumped for some powerbooks */
> - printk(KERN_ERR "%s: pmac_ide_do_setfeature disk not ready "
> - "before SET_FEATURE!\n", drive->name);
> - goto out;
> - }
> - udelay(10);
> hwif->OUTB(drive->ctl | 2, IDE_CONTROL_REG);
> hwif->OUTB(command, IDE_NSECTOR_REG);
> hwif->OUTB(SETFEATURES_XFER, IDE_FEATURE_REG);
> @@ -568,7 +558,7 @@ pmac_ide_do_setfeature(ide_drive_t *driv
> if (result)
> printk(KERN_ERR "%s: pmac_ide_do_setfeature disk not ready "
> "after SET_FEATURE !\n", drive->name);
> -out:
> +
> SELECT_MASK(drive, 0);
> if (result == 0) {
> drive->id->dma_ultra &= ~0xFF00;
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
