The Marvell bridge chips used on HighPoint SATA cards do not seem to support
the MWDMA modes (at least that caould be seen in their so-called drivers :-),
so the driver needs to account for this -- to achieve this:

- add mdma_filter() method from the original patch by Bartlomiej Zolnierkewicz
  with his consent, also adding the method callout to ide_rate_filter();

- install the method for all chips to only return empty mask if a SATA drive
  is detected on HPT372{AN]/374 chips...

Signed-off-by: Sergei Shtylyov <[EMAIL PROTECTED]>

---
This patch is against the current Linus' tree.
It has not been tested on a real SATA card...

 drivers/ide/ide-dma.c    |    9 +++++++--
 drivers/ide/ide.c        |    1 +
 drivers/ide/pci/hpt366.c |   23 +++++++++++++++++++++--
 include/linux/ide.h      |    1 +
 4 files changed, 30 insertions(+), 4 deletions(-)

Index: linux-2.6/drivers/ide/ide-dma.c
===================================================================
--- linux-2.6.orig/drivers/ide/ide-dma.c
+++ linux-2.6/drivers/ide/ide-dma.c
@@ -674,8 +674,13 @@ static unsigned int ide_get_mode_mask(id
                        mask &= 0x07;
                break;
        case XFER_MW_DMA_0:
-               if (id->field_valid & 2)
-                       mask = id->dma_mword & hwif->mwdma_mask;
+               if ((id->field_valid & 2) == 0)
+                       break;
+               if (hwif->mdma_filter)
+                       mask = hwif->mdma_filter(drive);
+               else
+                       mask = hwif->mwdma_mask;
+               mask &= id->dma_mword;
                break;
        case XFER_SW_DMA_0:
                if (id->field_valid & 2) {
Index: linux-2.6/drivers/ide/ide.c
===================================================================
--- linux-2.6.orig/drivers/ide/ide.c
+++ linux-2.6/drivers/ide/ide.c
@@ -398,6 +398,7 @@ static void ide_hwif_restore(ide_hwif_t 
 
        hwif->tuneproc                  = tmp_hwif->tuneproc;
        hwif->speedproc                 = tmp_hwif->speedproc;
+       hwif->mdma_filter               = tmp_hwif->mdma_filter;
        hwif->udma_filter               = tmp_hwif->udma_filter;
        hwif->selectproc                = tmp_hwif->selectproc;
        hwif->reset_poll                = tmp_hwif->reset_poll;
Index: linux-2.6/drivers/ide/pci/hpt366.c
===================================================================
--- linux-2.6.orig/drivers/ide/pci/hpt366.c
+++ linux-2.6/drivers/ide/pci/hpt366.c
@@ -1,5 +1,5 @@
 /*
- * linux/drivers/ide/pci/hpt366.c              Version 1.12    Aug 19, 2007
+ * linux/drivers/ide/pci/hpt366.c              Version 1.13    Sep 29, 2007
  *
  * Copyright (C) 1999-2003             Andre Hedrick <[EMAIL PROTECTED]>
  * Portions Copyright (C) 2001         Sun Microsystems, Inc.
@@ -114,7 +114,7 @@
  *   unify HPT36x/37x timing setup code and the speedproc handlers by joining
  *   the register setting lists into the table indexed by the clock selected
  * - set the correct hwif->ultra_mask for each individual chip
- * - add UltraDMA mode filtering for the HPT37[24] based SATA cards
+ * - add Ultra and MW DMA mode filtering for the HPT37[24] based SATA cards
  *     Sergei Shtylyov, <[EMAIL PROTECTED]> or <[EMAIL PROTECTED]>
  */
 
@@ -562,6 +562,24 @@ static u8 hpt3xx_udma_filter(ide_drive_t
        return check_in_drive_list(drive, bad_ata33) ? 0x00 : mask;
 }
 
+static u8 hpt3xx_mdma_filter(ide_drive_t *drive)
+{
+       ide_hwif_t *hwif        = HWIF(drive);
+       struct hpt_info *info   = pci_get_drvdata(hwif->pci_dev);
+
+       switch (info->chip_type) {
+       case HPT372 :
+       case HPT372A:
+       case HPT372N:
+       case HPT374 :
+               if (ide_dev_is_sata(drive->id))
+                       return 0x00;
+               /* Fall thru */
+       default:
+               return 0x07;
+       }
+}
+
 static u32 get_speed_setting(u8 speed, struct hpt_info *info)
 {
        int i;
@@ -1257,6 +1275,7 @@ static void __devinit init_hwif_hpt366(i
        hwif->busproc           = &hpt3xx_busproc;
 
        hwif->udma_filter       = &hpt3xx_udma_filter;
+       hwif->mdma_filter       = &hpt3xx_mdma_filter;
 
        /*
         * HPT3xxN chips have some complications:
Index: linux-2.6/include/linux/ide.h
===================================================================
--- linux-2.6.orig/include/linux/ide.h
+++ linux-2.6/include/linux/ide.h
@@ -723,6 +723,7 @@ typedef struct hwif_s {
        /* driver soft-power interface */
        int     (*busproc)(ide_drive_t *, int);
 #endif
+       u8 (*mdma_filter)(ide_drive_t *);
        u8 (*udma_filter)(ide_drive_t *);
 
        void (*ata_input_data)(ide_drive_t *, void *, u32);

-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to