I just succeeded in installing when choosing DHCP. alas we don't have DHCP
server, so I need to configure it myself. what's more, I get the following
warnings in boot time:
WARNING: the PCI BIOS assigned this PCI NE2k card to IRQ 0, which is
unlikely to work!
You should use the PCI BIOS setup to assign a valid IRQ line.
ne2k-pci.c: PCI NE2000 clone 'RealTek RTL-8029' at I/O 0xe000, IRQ 0
eth0: RealTek RTL-8029 found at I/O 0xe000 IRQ 0
what should I do next?
plz help
N
-----Original Message-----
From: Isaac Aaron [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, 15 August, 2000 9:05 AM
To: Noam Ben Haim
Cc: [EMAIL PROTECTED]; [EMAIL PROTECTED]
Subject: Re: installation problems RH6.2
How about removing the NIC, reinstalling and placing it back again?
Isaac Aaron
"Noam Ben
Haim" <noambh To: <[EMAIL PROTECTED]>
@ cc:
onsetinc.com> Subject: installation problems
RH6.2
Sent by:
linux-il-boun
ce@
cs.huji.ac.il
15/08/00
10:16
HI all
I added a PCI Network card, and since then I can't reinstall RH6.2. the
installation process is stuck at the point of doing the post installation
configuration. and I have to reboot the computer, ruining the
installation...
plz help
N
Noam Ben Haim
[EMAIL PROTECTED]
Tel: +972-9-9561615 ext 122
Fax: +972-9-9561610
=================================================================
To unsubscribe, send mail to [EMAIL PROTECTED] with
the word "unsubscribe" in the message body, e.g., run the command
echo unsubscribe | mail [EMAIL PROTECTED]
=================================================================
To unsubscribe, send mail to [EMAIL PROTECTED] with
the word "unsubscribe" in the message body, e.g., run the command
echo unsubscribe | mail [EMAIL PROTECTED]
