yes.... The Cisco router's frame ecapsulation type should not be set to
cisco.... it should be set to ietf. go into interface configuration mode
and type in "encapsulation frame-relay ietf"
Best regards
Yossi
From: "Ilya Konstantinov" <[EMAIL PROTECTED]>
To: "Linux-IL" <[EMAIL PROTECTED]>
Sent: Monday, February 26, 2001 4:30 PM
Subject: Bay Networks and Cisco
> Hi,
>
> I know this is a bit offtopic, but someone maybe might know ...
>
> Is there anything special which needs to be done in order to configure
> a simple Frame Relay connection between a Bay Networks router (Router
> Software 11.03) and a Cisco router?
>
> --
> Best regards,
> Ilya Konstantinov
>
> =================================================================
> To unsubscribe, send mail to [EMAIL PROTECTED] with
> the word "unsubscribe" in the message body, e.g., run the command
> echo unsubscribe | mail [EMAIL PROTECTED]
>
=================================================================
To unsubscribe, send mail to [EMAIL PROTECTED] with
the word "unsubscribe" in the message body, e.g., run the command
echo unsubscribe | mail [EMAIL PROTECTED]
