On Friday 14 March 2003 12:18, Yedidyah Bar-David wrote: > > Section "Monitor" > > Identifier "monitor1" > > VendorName "Generic" > > ModelName "1600x1200 @ 70 Hz" > > ## replaced 2 lines with data from Proview DX997 manual - shlomo - > > 12/3/03 ## HorizSync 31.5-88.0 > > ## VertRefresh 50-90 > > HorizSync 30.0-98.0 > > VertRefresh 50-160 > > What you did was not "on the safe side" - you put values higher than MDK's. > If they are from the monitor's reference, fine. Yours does, I think, > 1600x1200 @ 75Hz (maybe a bit more).
As the comment in XF86Config-4 says, the numbers are from the monitor's manual - that's what I meant by being on the safe side. In fact, your right that the manual also says that the monitor can handle more - [EMAIL PROTECTED] or [EMAIL PROTECTED] So maybe I should manually chose 75 in the Mandrake setup. As far as your explanation of the modeline is concerned - thanks - I'll read what you wrote and the documentation you recommended and see what I can learn. -- Shlomo Solomon http://come.to/shlomo.solomon Sent by KMail (KDE 3.0.5a) on LINUX Mandrake 9.0 ================================================================To unsubscribe, send mail to [EMAIL PROTECTED] with the word "unsubscribe" in the message body, e.g., run the command echo unsubscribe | mail [EMAIL PROTECTED]
