If it is because of some thing u tried recently, try renaming the back up
XF86Config.old file in /etc/X11/ to XF86Config (of course make a copy of the
existing XF86Config in the same directory.
If this does not work, u will have to run Xconfigurator again to set up your
X.
Its easier if u are using kernel 2.2.16 upwards with i810.
hope this helps
Ashwin
On Tuesday 14 November 2000 23:19, you wrote:
> Hello Everybody,
>
>
> I have i810 mother board. My Gnome worked fine for 3 t 4 times but then
> failed . The startx commands fails by giving the following message
>
> "Cannot allocate memory ....etc...."
>
> What should i do ??
>
> Can anybody tell me how to redect or refresh my hardware detection . May
> be it will start working again ...
>
> Do reply fast...
>
> Thanks in advance
>
> Sunil varghese
>
>
>
> ----------------------------------------------
> The mailing list archives are available at
> http://lists.linux-india.org/cgi-bin/wilma/LIH
----------------------------------------------
LIH is all for free speech. But it was created
for a purpose. Violations of the rules of
this list will result in stern action.
