> Hi!
> I have problems installing my second ethernet card
> in
> Linux 7.0 (kernel 2.2.16)
> 
> I installed the module ne2k-pci.o
> 
> Then I added the following to  /etc/modules.conf
>      alias eth1 ne2k-pci.o
> 
> The /etc/sysconfig/network-scripts/ifcfg-eth1 file
> is
> as follows:
> 
> DEVICE=eth1 
> IPADDR=192.168.110.11
> NETMASK=255.255.255.0
> BROADCAST=192.168.110.255
> ONBOOT=yes
> BOOTPROTO=bootp
> USERCTL=no
> 
> I do not use LILO since linux is loaded on my system
> after 1024 cylinders. I use a floppy for booting
> Linux.
> 
> On rebooting, bringing up eth0 and eth1 both give an
> OK
> 
> But ifconfig gives the following :
> 
> eth0      Link encap:Ethernet 
> HWaddr00:04:23:0F:5B:F6
>  
>           inet addr:192.168.110.20 
> Bcast:192.168.110.255  Mask:255.255.255.0
>           UP BROADCAST RUNNING MULTICAST  MTU:1500 
> Metric:1
>           RX packets:19 errors:0 dropped:0
> overruns:0
> frame:0
>           TX packets:0 errors:0 dropped:0 overruns:0
> carrier:0
>           collisions:0 txqueuelen:100 
>           Interrupt:10 Base address:0xac00 
> 
> lo        Link encap:Local Loopback  
>           inet addr:127.0.0.1  Mask:255.0.0.0
>           UP LOOPBACK RUNNING  MTU:3924  Metric:1
>           RX packets:14 errors:0 dropped:0
> overruns:0
> frame:0
>           TX packets:14 errors:0 dropped:0
> overruns:0
> carrier:0
>           collisions:0 txqueuelen:0 
> 
> 
> eth1 is not mentioned here. ifconfig eth1 gives the
> foll:
> 
> eth1      Link encap:Ethernet  HWaddr
> 00:00:21:27:B7:20  
>           inet addr:192.168.110.11 
> Bcast:192.168.110.255  Mask:255.255.255.0
>           BROADCAST RUNNING MULTICAST  MTU:1500 
> Metric:1
>           RX packets:0 errors:0 dropped:0 overruns:0
> frame:0
>           TX packets:0 errors:0 dropped:0 overruns:0
> carrier:0
>           collisions:0 txqueuelen:100 
>           Base address:0xa800 
> 
> I guess this indicates that the second card is
> detected, but its IRQ is not mentioned here. 
> 
> ifconfig eth1 up 
> gives an error of "Resource Temporarily Unavailable"
> 
> Cld anyone pls suggest a way to make the second card
> work?
> 
> TIA
> Seeker


________________________________________________________________________
Looking for a job?  Visit Yahoo! India Careers
      Visit http://in.careers.yahoo.com

_______________________________________________
linux-india-help mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/linux-india-help

Reply via email to