Hi friends,
I have installed a PCQ Linux 7.1 on my friends machine. I am not
able to configure the lan card. Please Help.
output of lspci -v is as follows:
<lspci>
00:07.2 USB Controller: VIA Technologies, Inc. UHCI USB (rev 02) (prog-if 00
[UHCI])
Subsystem: Unknown device 0925:1234
Flags: bus master, medium devsel, latency 64, IRQ 11
I/O ports at e400 [size=32]
00:07.3 Host bridge: VIA Technologies, Inc. VT82C586B ACPI (rev 10)
Flags: medium devsel
00:10.0 Ethernet controller: D-Link System Inc: Unknown device 1300 (rev 10)
Subsystem: D-Link System Inc: Unknown device 1300
Flags: bus master, medium devsel, latency 64, IRQ 10
I/O ports at e800 [size=256]
Memory at e6000000 (32-bit, non-prefetchable) [size=256]
Capabilities: [50] Power Management version 2
00:13.0 VGA compatible controller: Cirrus Logic GD 5430/40 [Alpine] (rev 22)
(prog-if 00 [VGA])
Flags: medium devsel, IRQ 12
Memory at e4000000 (32-bit, prefetchable) .....
<lspci>
$dmesg | grep eth0 doesnot give any o/p
$ifconfig -v gives the following
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:6 errors:0 dropped:0 overruns:0 frame:0
TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
I think the Linux has detected the card, but the driver probe failed.
What should I do to install the driver?
Thanks in advance.
Liyju Janardhan.
_______________________________________________________________
Don't miss the 2002 Sprint PCS Application Developer's Conference
August 25-28 in Las Vegas -- http://devcon.sprintpcs.com/adp/index.cfm
_______________________________________________
linux-india-help mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/linux-india-help
