On Tue, Sep 03, 2002 at 10:55:45AM +0530, Prashanth wrote:
>
> I know these things and I have already tried. I forgot to tell
> you that, all my partitions are reiserfs. Does this cause to
> deny booting ?
>
Answer is yes and no. Mounting various devices need the appropr-
iate devices compiled or loaded as a module for the kernel. If
the kernel is compiled with static reiserfs support then there
should be no problems. Since you are booting through loadlin, no
linux partition can be accessed unless the kernel has the built-
in capability to do so. Normally only ext2 support is default.
If reiserfs support is not precompiled, the answer is yes, boot
process will stop for obvious reasons. Perhaps, you may have to
re-compile your kernel and then try.
HTH
Bish
--
:
####[ Linux One Stanza Tip (LOST) ]###########################
Sub : Are your X paramaters correct ? LOST #181
In case not, you may face situations where either the screen
does not fit properly, or there is flicker or snow. Under such
conditions probe for the actual parameters for your card using
"xvidtune" utility, in the [auto] mode ... Try output values
as Modeline in the Monitor section of XF86Config file.
####<[EMAIL PROTECTED]>################################
:
-------------------------------------------------------
This sf.net email is sponsored by: OSDN - Tired of that same old
cell phone? Get a new here for FREE!
https://www.inphonic.com/r.asp?r=sourceforge1&refcode1=vs3390
_______________________________________________
linux-india-help mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/linux-india-help
