On Sun, Sep 08, 2002 at 06:23:09AM +0530, little wrote:
> how to run gui in dragon linux ? startx is not working
> help me out
>
---end quoted text---
Don't know about Dragon Linux ... but do you have Xfree86
installed ? There are some configuration file, some driver
files (e.g. XF86_SVGA, or some other for your card), fonts
etc. installed ? The binary "xinit" is a must ... if you dont
have xinit on your box, install "X" first. Check out with:
$which xinit
It is usually at /usr/X11R6/bin/xinit. startx is merely an sh
script to supply clientargs and serverargs to xinit.
If it is only startx missing, you can be helped in putting a
startx script in place ...
HTH
Bish
--
:
####[ GNU/Linux One Stanza Tip (LOST) ]#######################
Sub : Are your X paramaters correct ? LOST #181
In case not, you may face situations where either the screen
does not fit properly, or there is flicker or snow. Under such
conditions probe for the actual parameters for your card using
"xvidtune" utility, in the [auto] mode ... Try output values
as Modeline in the Monitor section of XF86Config file.
####<[EMAIL PROTECTED]>################################
:
-------------------------------------------------------
This sf.net email is sponsored by: OSDN - Tired of that same old
cell phone? Get a new here for FREE!
https://www.inphonic.com/r.asp?r=sourceforge1&refcode1=vs3390
_______________________________________________
linux-india-help mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/linux-india-help
