On 6/14/05, Raj Mathur <[EMAIL PROTECTED]> wrote: > Uh, no. If you want to install Sarge with RAID-1, create identical > partitions on both disks and tell Sarge you want to use them as > Physical Volume for RAID. Then go into the Sarge Configure software > RAID menu and create MD devices (RAID volumes) -- you will be prompted > for the partitions to use for each RAID volume. > > Once the RAID volumes are created you can continue specifying mount > point, FS type, etc for each volume exactly as you would for a normal > disk partition. > > All this is from the last time I installed Sarge with RAID, over 6 > months ago, so may be a bit rusty. >
Thankyou so much Raj you gave me all the info I neded and 1 compleated RAID1 configuration on Sarge with the above steps successfully. BUT I think the Sarge installer instaled GRUB only on hd0 and not on hd1!!! Could you please tell me how to verify this and how do I test my RAID1 to see if it is working fine???? If I remove the first hard disk will it boot from the Second one and work fine??? and if I replace the first Hard disk will it rejoin te array??? thanks a million once again :-) kind Regards Siju ------------------------------------------------------- This SF.Net email is sponsored by: NEC IT Guy Games. How far can you shotput a projector? How fast can you ride your desk chair down the office luge track? If you want to score the big prize, get to know the little guy. Play to win an NEC 61" plasma display: http://www.necitguy.com/?r _______________________________________________ linux-india-help mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/linux-india-help
