On Tue, Mar 06, 2001 at 11:06:52PM -0800, Dag Brattli wrote:
> Hi,
>
> In pyobex i measure the round-trip time, and dynamically change
> the mtu so that the latency is acceptable. If you set the mtu to high
> it might take a _very_ long time before you can cancel the current
> operation. The mtu I set is something between the minimum
> mtu allowed and the mtu published by the receiver. For this same
> reason I always publish a maximum mtu to the peer device, which
> has to figure out itself which mtu is practical to use to (some devices
> don't, like the HP capshare ;-)
>
> -- Dag
Ok, let's forget about it. In fact, I don't really need it
(most of my URLs are short), I just thought it was cool...
Jean
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www.pasta.cs.UiT.No/mailman/listinfo/linux-irda
