Hi all,
Im trying to get my ir port working on my linux laptop (Sharp A500) and point
to a palm iiixe
I have a fresh install of RH7.1 with the source of irda-utils-0.9.14.tar.gz
compiled and installed
A findchip -dv reports
Found NSC PC87338 Controller at 0x398, DevID=0x0b, Rev.2
SIR Base 0x2f8, FIR Base 0x2f8
IRQ=3, DMA=1
Enabled=yes, Suspended:no
UART compatible:yes
Half duplex delay = 0 us
In my /etc/modules.conf
alias tty-1disc-11 irtty
alias char-major-161 ircomm-tty
alias char-major-10-187 irnet
alias irda0 nsc-ircc
options nsc-ircc
then i try running (as root)
irattach irda0 -s 1
After doing this i dont see any modules show up in lsmod...
But if i try to use SIR mode ( i think)
irattach /dev/ttyS1 -s 1
i see irtty and irda show up in lsmod.. then i can do a irdadump but i only
seem to get it send info (ie: > ffffffff S=6 s=0 (14))
Id rather use the nsc driver because its supposed to be faster, but i really
cant either to work... any ideas?
mn
Mark Nold
[EMAIL PROTECTED]
Senior Consultant
Change is inevitable, except from vending machines.
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www.pasta.cs.UiT.No/mailman/listinfo/linux-irda
