Hi
in short, i can't get insmod to load smc-ircc.o
my MB says i have a FDC37N3869-MD
the insmod command i'm using is below, but i'm a newbie w/r to loading
modules :(
when i run findchip -v it finds an FDC37N869 (note the missing 3?)
[root@localhost root]# findchip -v
Found SMC FDC37N869 Controller at 0x370, DevID=0x02, Rev. 0
SIR Base 0x2f8, FIR Base 0x158
IRQ = 3, DMA = 0
Enabled: yes, Suspended: no
UART compatible: yes
Half duplex delay = 3 us
so next i try to use insmod.. this is the first time i've had to load a
module with paramaters, but i think i'm using the right syntax (plz tell if
i'm not!)
[root@localhost root]# insmod smc-ircc ircc_dma=0 ircc_irq=3 ircc_fir=0x158
ircc_sir=0x2f8 ircc_cfg=0x370
the only paramater i'm not sure about is the ircc_cfg one. anyway, it returns:
init_module: No such device
Hint: insmod errors can be caused by incorrect module parameters, including
invalid IO or IRQ parameters
im using a Compaq Evo N150 Laptop.. It has an Infared port on the back (duh)
and has an SMsC Super I/O controller, which is a FDC37N3869-MD (i read it off
the chip)
Many thanks
- Jeff
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www.pasta.cs.UiT.No/mailman/listinfo/linux-irda
