Thanks. That did the trick.
Rajesh
On Mon, 27 Nov 2000, Phillipp Hahn wrote
> On Sun, 26 Nov 2000, Rajesh Krishna Balan wrote:
> > when i do modprobe nsc-ircc i get the following error message.
>...
> > nsc-ircc, Found chip at base=0x02e
> > nsc_ircc_open(), can't get iobase of 0x2f8
> The kernel-module for serial devices claims that io-port.
> A "cat /proc/ioports" should confirm this.
> Call "setserial /dev/ttyS1 uart none" to revoke that.
> If you're using Debian fix "/etc/serial.conf" to make it permanent.
>
> BYtE
> Philipp
--
/ / (_)__ __ ____ __ Philipp Hahn
/ /__/ / _ \/ // /\ \/ /
/____/_/_//_/\_,_/ /_/\_\ [EMAIL PROTECTED]
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www.pasta.cs.UiT.No/mailman/listinfo/linux-irda
