commit: http://blackfin.uclinux.org/git/?p=linux-kernel;a=commitdiff;h=752b5fe4e8e2a934211422a6d1717d5fb6257b0c branch: http://blackfin.uclinux.org/git/?p=linux-kernel;a=shortlog;h=refs/heads/2011R1
Reported-by: Bob Maris <[email protected]> TWI transfer interrupts may be lost when system is heavily handling other interrupts, while current transfer handler depends on each accurate interrupt and misses some data in this case. Because there are 2 2-byte FIFOs in blackfin TWI controller, the occurrence of the data loss can be reduced by reading till the RX FIFO is empty and writing till the TX FIFO is full. Signed-off-by: Sonic Zhang <[email protected]> --- drivers/i2c/busses/i2c-bfin-twi.c | 47 +++++++++++++++++++++--------------- 1 files changed, 27 insertions(+), 20 deletions(-) diff --git a/drivers/i2c/busses/i2c-bfin-twi.c b/drivers/i2c/busses/i2c-bfin-twi.c index 3b39360..35105fe 100644 --- a/drivers/i2c/busses/i2c-bfin-twi.c +++ b/drivers/i2c/busses/i2c-bfin-twi.c @@ -88,33 +88,40 @@ static void bfin_twi_handle_interrupt(struct bfin_twi_iface *iface, unsigned short mast_stat = read_MASTER_STAT(iface); if (twi_int_status & XMTSERV) { + if (iface->writeNum <= 0) { + /* start receive immediately after complete sending in + * combine mode. + */ + if (iface->cur_mode == TWI_I2C_MODE_COMBINED) + write_MASTER_CTL(iface, + read_MASTER_CTL(iface) | MDIR); + else if (iface->manual_stop) + write_MASTER_CTL(iface, + read_MASTER_CTL(iface) | STOP); + else if (iface->cur_mode == TWI_I2C_MODE_REPEAT && + iface->cur_msg + 1 < iface->msg_num) { + if (iface->pmsg[iface->cur_msg + 1].flags & + I2C_M_RD) + write_MASTER_CTL(iface, + read_MASTER_CTL(iface) | + MDIR); + else + write_MASTER_CTL(iface, + read_MASTER_CTL(iface) & + ~MDIR); + } + } /* Transmit next data */ - if (iface->writeNum > 0) { + while (iface->writeNum > 0 && + (read_FIFO_STAT(iface) & XMTSTAT) != XMT_FULL) { SSYNC(); write_XMT_DATA8(iface, *(iface->transPtr++)); iface->writeNum--; } - /* start receive immediately after complete sending in - * combine mode. - */ - else if (iface->cur_mode == TWI_I2C_MODE_COMBINED) - write_MASTER_CTL(iface, - read_MASTER_CTL(iface) | MDIR); - else if (iface->manual_stop) - write_MASTER_CTL(iface, - read_MASTER_CTL(iface) | STOP); - else if (iface->cur_mode == TWI_I2C_MODE_REPEAT && - iface->cur_msg + 1 < iface->msg_num) { - if (iface->pmsg[iface->cur_msg + 1].flags & I2C_M_RD) - write_MASTER_CTL(iface, - read_MASTER_CTL(iface) | MDIR); - else - write_MASTER_CTL(iface, - read_MASTER_CTL(iface) & ~MDIR); - } } if (twi_int_status & RCVSERV) { - if (iface->readNum > 0) { + while (iface->readNum > 0 && + (read_FIFO_STAT(iface) & RCVSTAT)) { /* Receive next data */ *(iface->transPtr) = read_RCV_DATA8(iface); if (iface->cur_mode == TWI_I2C_MODE_COMBINED) {
_______________________________________________ Linux-kernel-commits mailing list [email protected] https://blackfin.uclinux.org/mailman/listinfo/linux-kernel-commits
