After 57a38effa598 (net: phy: micrel: disable broadcast for KSZ8081/KSZ8091) the macb0 interface has difficulties to come back from power saving mode if address not explicitly set up. As the micrel phy on the board is actually configured to show up at address 1 we use this explicitly. Adding the phy node and its real address fixes the issue.
The phy IRQ and associated pinmux node is also added. Signed-off-by: Nicolas Ferre <[email protected]> Cc: [email protected] # 4.4+ // manual merge needed --- v2: - correct typos in commit message - add a sentence about the IRQ + pinmux as well - add stable tag arch/arm/boot/dts/at91-sama5d2_xplained.dts | 12 +++++++++++- 1 file changed, 11 insertions(+), 1 deletion(-) diff --git a/arch/arm/boot/dts/at91-sama5d2_xplained.dts b/arch/arm/boot/dts/at91-sama5d2_xplained.dts index 77ddff036409..e683856c507c 100644 --- a/arch/arm/boot/dts/at91-sama5d2_xplained.dts +++ b/arch/arm/boot/dts/at91-sama5d2_xplained.dts @@ -114,9 +114,15 @@ macb0: ethernet@f8008000 { pinctrl-names = "default"; - pinctrl-0 = <&pinctrl_macb0_default>; + pinctrl-0 = <&pinctrl_macb0_default &pinctrl_macb0_phy_irq>; phy-mode = "rmii"; status = "okay"; + + ethernet-phy@1 { + reg = <0x1>; + interrupt-parent = <&pioA>; + interrupts = <73 IRQ_TYPE_LEVEL_LOW>; + }; }; pdmic@f8018000 { @@ -300,6 +306,10 @@ bias-disable; }; + pinctrl_macb0_phy_irq: macb0_phy_irq { + pinmux = <PIN_PC9__GPIO>; + }; + pinctrl_pdmic_default: pdmic_default { pinmux = <PIN_PB26__PDMIC_DAT>, <PIN_PB27__PDMIC_CLK>; -- 2.1.3
