Hi Joshua,
Am Dienstag, den 02.02.2016, 14:13 -0800 schrieb Joshua Clayton:
> Uniwest evi is a portable electrical eddy current non-destructive
> testing device.
>
> Signed-off-by: Joshua Clayton <[email protected]>
> ---
> arch/arm/boot/dts/Makefile | 1 +
> arch/arm/boot/dts/imx6q-evi.dts | 506
> ++++++++++++++++++++++++++++++++++++++++
> 2 files changed, 507 insertions(+)
> create mode 100644 arch/arm/boot/dts/imx6q-evi.dts
>
> diff --git a/arch/arm/boot/dts/Makefile b/arch/arm/boot/dts/Makefile
> index c4f42a78..4a4ef29 100644
> --- a/arch/arm/boot/dts/Makefile
> +++ b/arch/arm/boot/dts/Makefile
> @@ -326,6 +326,7 @@ dtb-$(CONFIG_SOC_IMX6Q) += \
> imx6q-cubox-i.dtb \
> imx6q-dfi-fs700-m60.dtb \
> imx6q-dmo-edmqmx6.dtb \
> + imx6q-evi.dtb \
> imx6q-gk802.dtb \
> imx6q-gw51xx.dtb \
> imx6q-gw52xx.dtb \
> diff --git a/arch/arm/boot/dts/imx6q-evi.dts b/arch/arm/boot/dts/imx6q-evi.dts
> new file mode 100644
> index 0000000..10f566e
> --- /dev/null
> +++ b/arch/arm/boot/dts/imx6q-evi.dts
> @@ -0,0 +1,506 @@
[...]
> +/dts-v1/;
> +#include "imx6q.dtsi"
> +#include <dt-bindings/gpio/gpio.h>
> +#include <dt-bindings/interrupt-controller/irq.h>
> +
> +/ {
> + model = "Uniwest Evi";
> + compatible = "uniwest,imx6q-evi", "fsl,imx6q";
[...]
> + panel {
> + compatible = "sharp,lq101k1ly04";
> +
> + port {
> + panel_in: endpoint {
> + remote-endpoint = <&lvds0_out>;
> + };
> + };
> + };
> +};
[...]
> +&ldb {
> + status = "okay";
> +
> + lvds0: lvds-channel@0 {
> + fsl,data-mapping = "jeida";
> + fsl,data-width = <24>;
The "sharp,lq101k1ly04" panel compatible already specifies the bus
format (it is set to MEDIA_BUS_FMT_RGB888_1X7X4_JEIDA in the
simple-panel entry), these two properties can be removed.
> + status = "okay";
> +
> + port@4 {
> + reg = <4>;
> + lvds0_out: endpoint {
> + remote-endpoint = <&panel_in>;
> + };
> + };
> + };
> +};
[...]
regards
Philipp
