On Sat, 30 Dec 2006 18:37:18 +0100 (MET), Mikael Pettersson wrote:
>This patch against 2.6.20-rc2 adds partial ATAPI support to
>the sata_promise driver. This patch is preliminary and for
>review only.
...
>As to why CD-writing fails with DMA enabled, I suspect that I
>either need to blacklist specific packet commands from using
>DMA, or ...
That was it: ->check_atapi_dma() needs to inspect the packet
command and only enable DMA for bulk data transfers. With this
change sata_promise successfully both reads and writes CDs.
The rules for which commands should use DMA are taken from
Promise's drivers. I missed this filter originally because it
is located in their high-level Linux glue driver while I was
mostly studying their low-level hardware driver. The filter matches
the corresponding code in pata_pdc2027x.c, with the exception
of an additional no-DMA restriction for WRITE_10 with large LBA.
The patch below goes on top of the first preliminary patch.
/Mikael
--- linux-2.6.20-rc3/drivers/ata/sata_promise.c.~1~ 2007-01-01
17:13:05.000000000 +0100
+++ linux-2.6.20-rc3/drivers/ata/sata_promise.c 2007-01-01 19:14:00.000000000
+0100
@@ -39,6 +39,7 @@
#include <linux/interrupt.h>
#include <linux/sched.h>
#include <linux/device.h>
+#include <scsi/scsi.h>
#include <scsi/scsi_host.h>
#include <scsi/scsi_cmnd.h>
#include <linux/libata.h>
@@ -430,16 +431,10 @@ static void pdc_qc_prep(struct ata_queue
qc->tf.protocol = ATA_PROT_DMA;
pdc_pkt_header(&qc->tf, qc->ap->prd_dma, qc->dev->devno,
pp->pkt);
qc->tf.protocol = ATA_PROT_ATAPI_DMA;
- if (qc->dev->cdb_len & ~0x1E) { /* 2/4/6/8/10/12/14/16 are Ok */
- printk(KERN_ERR "%s: bad cdb_len %u\n", __FUNCTION__,
qc->dev->cdb_len);
- BUG();
- }
+ /* we can represent cdb lengths 2/4/6/8/10/12/14/16 */
+ BUG_ON(qc->dev->cdb_len & ~0x1E);
pp->pkt[12] = (((qc->dev->cdb_len >> 1) & 7) << 5) | 0x00 |
0x08;
memcpy(pp->pkt+13, qc->cdb, qc->dev->cdb_len);
-#if 0
- /* pdc-ultra/cam/cam_ata.c will pad SG length to a multiple
- of 4 here, but libata has already done that for us */
-#endif
break;
default:
@@ -788,7 +783,29 @@ static void pdc_exec_command_mmio(struct
static int pdc_check_atapi_dma(struct ata_queued_cmd *qc)
{
- return 0; /* ATAPI DMA is supported */
+ u8 *scsicmd = qc->scsicmd->cmnd;
+ int pio = 1; /* atapi dma off by default */
+
+ /* Whitelist commands that may use DMA. */
+ switch (scsicmd[0]) {
+ case WRITE_12:
+ case WRITE_10:
+ case WRITE_6:
+ case READ_12:
+ case READ_10:
+ case READ_6:
+ case 0xad: /* READ_DVD_STRUCTURE */
+ case 0xbe: /* READ_CD */
+ pio = 0;
+ }
+ /* -45150 (FFFF4FA2) to -1 (FFFFFFFF) shall use PIO mode */
+ if (scsicmd[0] == WRITE_10) {
+ unsigned int lba;
+ lba = (scsicmd[2] << 24) | (scsicmd[3] << 16) | (scsicmd[4] <<
8) | scsicmd[5];
+ if (lba >= 0xFFFF4FA2)
+ pio = 1;
+ }
+ return pio;
}
static void pdc_ata_setup_port(struct ata_ioports *port, unsigned long base)
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
