The GPMC WAIT pin status are now available over gpiolib. Update the omap_dev_ready() function to use gpio instead of directly accessing GPMC register space.
Signed-off-by: Roger Quadros <[email protected]> --- .../devicetree/bindings/mtd/gpmc-nand.txt | 2 ++ drivers/mtd/nand/omap2.c | 29 ++++++++++++++-------- include/linux/platform_data/mtd-nand-omap2.h | 2 +- 3 files changed, 21 insertions(+), 12 deletions(-) diff --git a/Documentation/devicetree/bindings/mtd/gpmc-nand.txt b/Documentation/devicetree/bindings/mtd/gpmc-nand.txt index 810b87b..256bb86 100644 --- a/Documentation/devicetree/bindings/mtd/gpmc-nand.txt +++ b/Documentation/devicetree/bindings/mtd/gpmc-nand.txt @@ -48,6 +48,7 @@ Optional properties: locating ECC errors for BCHx algorithms. SoC devices which have ELM hardware engines should specify this device node in .dtsi Using ELM for ECC error correction frees some CPU cycles. + - rb-gpios: GPIO specifier for the ready/busy# pin. For inline partition table parsing (optional): @@ -78,6 +79,7 @@ Example for an AM33xx board: ti,nand-xfer-type = "polled"; interrupt-parent = <&gpmc>; interrupts = <0>, <1>; + rb-gpios = <&gpmc 0 GPIO_ACTIVE_HIGH>; /* gpmc_wait0 */ gpmc,sync-clk-ps = <0>; gpmc,cs-on-ns = <0>; diff --git a/drivers/mtd/nand/omap2.c b/drivers/mtd/nand/omap2.c index 0a637c4..e7939f1 100644 --- a/drivers/mtd/nand/omap2.c +++ b/drivers/mtd/nand/omap2.c @@ -12,6 +12,7 @@ #include <linux/dmaengine.h> #include <linux/dma-mapping.h> #include <linux/delay.h> +#include <linux/gpio/consumer.h> #include <linux/module.h> #include <linux/interrupt.h> #include <linux/jiffies.h> @@ -183,6 +184,8 @@ struct omap_nand_info { struct nand_ecclayout oobinfo; /* fields specific for BCHx_HW ECC scheme */ struct device *elm_dev; + /* NAND ready gpio */ + struct gpio_desc *ready_gpiod; }; static inline struct omap_nand_info *mtd_to_omap(struct mtd_info *mtd) @@ -1024,21 +1027,16 @@ static int omap_wait(struct mtd_info *mtd, struct nand_chip *chip) } /** - * omap_dev_ready - calls the platform specific dev_ready function + * omap_dev_ready - checks the NAND Ready GPIO line * @mtd: MTD device structure + * + * Returns true if ready and false if busy. */ static int omap_dev_ready(struct mtd_info *mtd) { - unsigned int val = 0; struct omap_nand_info *info = mtd_to_omap(mtd); - val = readl(info->reg.gpmc_status); - - if ((val & 0x100) == 0x100) { - return 1; - } else { - return 0; - } + return gpiod_get_value(info->ready_gpiod); } /** @@ -1754,7 +1752,9 @@ static int omap_nand_probe(struct platform_device *pdev) info->gpmc_cs = pdata->cs; info->reg = pdata->reg; info->ecc_opt = pdata->ecc_opt; - info->dev_ready = pdata->dev_ready; + if (pdata->dev_ready) + dev_info(&pdev->dev, "pdata->dev_ready is deprecated\n"); + info->xfer_type = pdata->xfer_type; info->devsize = pdata->devsize; info->elm_of_node = pdata->elm_of_node; @@ -1786,6 +1786,13 @@ static int omap_nand_probe(struct platform_device *pdev) nand_chip->IO_ADDR_W = nand_chip->IO_ADDR_R; nand_chip->cmd_ctrl = omap_hwcontrol; + info->ready_gpiod = devm_gpiod_get_optional(&pdev->dev, "rb", + GPIOD_IN); + if (IS_ERR(info->ready_gpiod)) { + dev_err(dev, "failed to get ready gpio\n"); + return PTR_ERR(info->ready_gpiod); + } + /* * If RDY/BSY line is connected to OMAP then use the omap ready * function and the generic nand_wait function which reads the status @@ -1793,7 +1800,7 @@ static int omap_nand_probe(struct platform_device *pdev) * chip delay which is slightly more than tR (AC Timing) of the NAND * device and read status register until you get a failure or success */ - if (info->dev_ready) { + if (info->ready_gpiod) { nand_chip->dev_ready = omap_dev_ready; nand_chip->chip_delay = 0; } else { diff --git a/include/linux/platform_data/mtd-nand-omap2.h b/include/linux/platform_data/mtd-nand-omap2.h index 7f6de53..17d57a1 100644 --- a/include/linux/platform_data/mtd-nand-omap2.h +++ b/include/linux/platform_data/mtd-nand-omap2.h @@ -71,7 +71,6 @@ struct omap_nand_platform_data { int cs; struct mtd_partition *parts; int nr_parts; - bool dev_ready; bool flash_bbt; enum nand_io xfer_type; int devsize; @@ -82,5 +81,6 @@ struct omap_nand_platform_data { /* deprecated */ struct gpmc_nand_regs reg; struct device_node *of_node; + bool dev_ready; }; #endif -- 2.1.4
