OrangePi Plus board has two leds - green ("pwr") and red ("status")
and a switch ("sw4"). This patch describes them in a devicetree.Signed-off-by: Krzysztof Adamski <[email protected]> --- arch/arm/boot/dts/sun8i-h3-orangepi-plus.dts | 63 ++++++++++++++++++++++++++++ 1 file changed, 63 insertions(+) diff --git a/arch/arm/boot/dts/sun8i-h3-orangepi-plus.dts b/arch/arm/boot/dts/sun8i-h3-orangepi-plus.dts index e67df59..5f159d0 100644 --- a/arch/arm/boot/dts/sun8i-h3-orangepi-plus.dts +++ b/arch/arm/boot/dts/sun8i-h3-orangepi-plus.dts @@ -45,6 +45,7 @@ #include "sunxi-common-regulators.dtsi" #include <dt-bindings/gpio/gpio.h> +#include <dt-bindings/input/input.h> #include <dt-bindings/pinctrl/sun4i-a10.h> / { @@ -58,6 +59,68 @@ chosen { stdout-path = "serial0:115200n8"; }; + + leds { + compatible = "gpio-leds"; + pinctrl-names = "default"; + pinctrl-0 = <&leds_opc>; + + status_led { + label = "status:red:user"; + gpios = <&pio 0 15 GPIO_ACTIVE_HIGH>; + }; + }; + + r_leds { + compatible = "gpio-leds"; + pinctrl-names = "default"; + pinctrl-0 = <&leds_r_opc>; + + tx { + label = "pwr:green:user"; + gpios = <&r_pio 0 10 GPIO_ACTIVE_HIGH>; + default-state = "on"; + }; + }; + + r_gpio_keys { + compatible = "gpio-keys"; + input-name = "sw4"; + + pinctrl-names = "default"; + pinctrl-0 = <&sw_r_opc>; + + sw4@0 { + label = "sw4"; + linux,code = <BTN_0>; + gpios = <&r_pio 0 3 GPIO_ACTIVE_LOW>; + }; + }; +}; + +&pio { + leds_opc: led_pins@0 { + allwinner,pins = "PA15"; + allwinner,function = "gpio_out"; + allwinner,drive = <SUN4I_PINCTRL_10_MA>; + allwinner,pull = <SUN4I_PINCTRL_NO_PULL>; + }; +}; + +&r_pio { + leds_r_opc: led_pins@0 { + allwinner,pins = "PL10"; + allwinner,function = "gpio_out"; + allwinner,drive = <SUN4I_PINCTRL_10_MA>; + allwinner,pull = <SUN4I_PINCTRL_NO_PULL>; + }; + + sw_r_opc: key_pins@0 { + allwinner,pins = "PL03"; + allwinner,function = "gpio_in"; + allwinner,drive = <SUN4I_PINCTRL_10_MA>; + allwinner,pull = <SUN4I_PINCTRL_NO_PULL>; + }; }; &mmc0 { -- 2.1.4
