From: Roger Quadros <[email protected]> If bootloader has set a wrong DPLL then we must trash those values and re-program it anyways. This fixes USB3 devices not being enumerated on beagle-x15 if usb was started in u-boot.
We don't re-program SATA DPLL if it is locked as it was causing SATA failures if device was hotpluged after boot. Reported-by: Robert Nelson <[email protected]> Signed-off-by: Roger Quadros <[email protected]> Signed-off-by: Kishon Vijay Abraham I <[email protected]> --- drivers/phy/phy-ti-pipe3.c | 15 +++++++++++---- 1 file changed, 11 insertions(+), 4 deletions(-) diff --git a/drivers/phy/phy-ti-pipe3.c b/drivers/phy/phy-ti-pipe3.c index 0a477d2..bf46844 100644 --- a/drivers/phy/phy-ti-pipe3.c +++ b/drivers/phy/phy-ti-pipe3.c @@ -293,11 +293,18 @@ static int ti_pipe3_init(struct phy *x) ret = ti_pipe3_dpll_wait_lock(phy); } - /* Program the DPLL only if not locked */ + /* SATA has issues if re-programmed when locked */ val = ti_pipe3_readl(phy->pll_ctrl_base, PLL_STATUS); - if (!(val & PLL_LOCK)) - if (ti_pipe3_dpll_program(phy)) - return -EINVAL; + if ((val & PLL_LOCK) && of_device_is_compatible(phy->dev->of_node, + "ti,phy-pipe3-sata")) + return ret; + + /* Program the DPLL */ + ret = ti_pipe3_dpll_program(phy); + if (ret) { + ti_pipe3_disable_clocks(phy); + return -EINVAL; + } return ret; } -- 1.7.9.5
