Add the i2c2 and rmi4 nodes to enable the Synaptics touchscreen found in the Honami.
Signed-off-by: Bjorn Andersson <[email protected]> --- .../boot/dts/qcom-msm8974-sony-xperia-honami.dts | 59 ++++++++++++++++++++++ 1 file changed, 59 insertions(+) diff --git a/arch/arm/boot/dts/qcom-msm8974-sony-xperia-honami.dts b/arch/arm/boot/dts/qcom-msm8974-sony-xperia-honami.dts index 3fb4dada6b0d..0d414ef9d3d0 100644 --- a/arch/arm/boot/dts/qcom-msm8974-sony-xperia-honami.dts +++ b/arch/arm/boot/dts/qcom-msm8974-sony-xperia-honami.dts @@ -311,6 +311,45 @@ pinctrl-0 = <&blsp1_uart2_pin_a>; }; + i2c@f9924000 { + status = "ok"; + + clock-frequency = <355000>; + qcom,src-freq = <50000000>; + + pinctrl-names = "default"; + pinctrl-0 = <&i2c2_pins>; + + synaptics@2c { + compatible = "syna,rmi4-i2c"; + reg = <0x2c>; + + interrupts-extended = <&msmgpio 61 IRQ_TYPE_EDGE_FALLING>; + + #address-cells = <1>; + #size-cells = <0>; + + vdd-supply = <&pm8941_l22>; + vio-supply = <&pm8941_lvs3>; + + pinctrl-names = "default"; + pinctrl-0 = <&ts_int_pin>; + + syna,startup-delay-ms = <10>; + + rmi4-f01@1 { + reg = <0x1>; + syna,nosleep-mode = <1>; + }; + + rmi4-f11@11 { + reg = <0x11>; + touchscreen-inverted-x; + syna,sensor-type = <1>; + }; + }; + }; + pinctrl@fd510000 { blsp1_uart2_pin_a: blsp1-uart2-pin-active { rx { @@ -330,6 +369,16 @@ }; }; + i2c2_pins: i2c2 { + mux { + pins = "gpio6", "gpio7"; + function = "blsp_i2c2"; + + drive-strength = <2>; + bias-disable; + }; + }; + sdhc1_pin_a: sdhc1-pin-active { clk { pins = "sdc1_clk"; @@ -366,6 +415,16 @@ }; }; + ts_int_pin: touch-int { + pin { + pins = "gpio61"; + function = "gpio"; + + drive-strength = <2>; + bias-disable; + input-enable; + }; + }; }; dma-controller@f9944000 { -- 2.5.0
