This patch fixes the following checkpatch.pl warning in rtsx_chip.h:
WARNING: Block comments use a trailing */ on a separate line

Signed-off-by: Sergio Paracuellos <sergio.paracuel...@gmail.com>
---
 drivers/staging/rts5208/rtsx_chip.h | 52 +++++++++++++++++++------------------
 1 file changed, 27 insertions(+), 25 deletions(-)

diff --git a/drivers/staging/rts5208/rtsx_chip.h 
b/drivers/staging/rts5208/rtsx_chip.h
index 6ef34fa..f366428 100644
--- a/drivers/staging/rts5208/rtsx_chip.h
+++ b/drivers/staging/rts5208/rtsx_chip.h
@@ -44,8 +44,10 @@
        #define MG_SET_ICV_SLOW
        /* HW may miss ERR/CMDNK signal when sampling INT status. */
        #define MS_SAMPLE_INT_ERR
-       /* HW DO NOT support Wait_INT function during READ_BYTES
-        * transfer mode */
+       /*
+        * HW DO NOT support Wait_INT function
+        * during READ_BYTES transfer mode
+        */
        #define READ_BYTES_WAIT_INT
 #endif
 
@@ -101,17 +103,17 @@
 #define TRANSPORT_NO_SENSE     2  /* Command failed, no auto-sense    */
 #define TRANSPORT_ERROR                3   /* Transport bad (i.e. device dead) 
*/
 
-/*-----------------------------------
-    Start-Stop-Unit
------------------------------------*/
+/*
+ * Start-Stop-Unit
+ */
 #define STOP_MEDIUM                    0x00    /* access disable         */
 #define MAKE_MEDIUM_READY              0x01    /* access enable          */
 #define UNLOAD_MEDIUM                  0x02    /* unload                 */
 #define LOAD_MEDIUM                    0x03    /* load                   */
 
-/*-----------------------------------
-    STANDARD_INQUIRY
------------------------------------*/
+/*
+ * STANDARD_INQUIRY
+ */
 #define QULIFIRE                0x00
 #define AENC_FNC                0x00
 #define TRML_IOP                0x00
@@ -128,17 +130,15 @@
 #define PRDCT_REV_LEN           4               /* Product LOT Length       */
 
 /* Dynamic flag definitions: used in set_bit() etc. */
-#define RTSX_FLIDX_TRANS_ACTIVE                18  /* 0x00040000  transfer is 
active */
-#define RTSX_FLIDX_ABORTING            20  /* 0x00100000 abort is in
-                                            * progress */
-#define RTSX_FLIDX_DISCONNECTING       21  /* 0x00200000 disconnect
-                                            * in progress */
+#define RTSX_FLIDX_TRANS_ACTIVE                18  /* 0x00040000 transfer is 
active     */
+#define RTSX_FLIDX_ABORTING            20  /* 0x00100000 abort is in progress  
 */
+#define RTSX_FLIDX_DISCONNECTING       21  /* 0x00200000 disconnect in 
progress */
+
 #define ABORTING_OR_DISCONNECTING      ((1UL << US_FLIDX_ABORTING) | \
                                         (1UL << US_FLIDX_DISCONNECTING))
-#define RTSX_FLIDX_RESETTING           22  /* 0x00400000 device reset
-                                            * in progress */
-#define RTSX_FLIDX_TIMED_OUT           23  /* 0x00800000 SCSI
-                                            * midlayer timed out */
+
+#define RTSX_FLIDX_RESETTING           22  /* 0x00400000 device reset in 
progress */
+#define RTSX_FLIDX_TIMED_OUT           23  /* 0x00800000 SCSI midlayer timed 
out  */
 
 #define DRCT_ACCESS_DEV         0x00    /* Direct Access Device      */
 #define RMB_DISC                0x80    /* The Device is Removable   */
@@ -173,9 +173,9 @@
 #define        FIRST_RESET             0x01
 #define        USED_EXIST              0x02
 
-/*-----------------------------------
-    SENSE_DATA
------------------------------------*/
+/*
+ * SENSE_DATA
+ */
 /*---- valid ----*/
 #define SENSE_VALID             0x80    /* Sense data is valid as SCSI2     */
 #define SENSE_INVALID           0x00    /* Sense data is invalid as SCSI2   */
@@ -706,9 +706,9 @@ struct rtsx_chip {
        int                     cur_card;
 
        unsigned long   need_release;           /* need release bit map */
-       unsigned long   need_reset;             /* need reset
-                                                * bit map */
-       /* Flag to indicate that this card is just resumed from SS state,
+       unsigned long   need_reset;             /* need reset bit map */
+       /*
+        * Flag to indicate that this card is just resumed from SS state,
         * and need released before being resetted
         */
        unsigned long           need_reinit;
@@ -726,8 +726,10 @@ struct rtsx_chip {
        u8      card_ejected;   /* card ejected bit map */
        u8      card_wp;        /* card write protected bit map */
 
-       u8      lun_mc;         /* flag to indicate whether to answer
-                                * MediaChange */
+       u8      lun_mc;         /*
+                                * flag to indicate whether to answer
+                                * MediaChange
+                                */
 
 #ifndef LED_AUTO_BLINK
        int                     led_toggle_counter;
-- 
1.9.1

Reply via email to