On Tue, 01 Nov 2016, Linus Walleij wrote:
> Since commit c4dd1ba355aae2bc3d1213da6c66c53e3c31e028
> ("mfd: stmpe: Add reset support for all STMPE variant")
> we're resetting the STMPE expanders before use.
>
> This caused a regression on the STMP2401 on the Nomadik
> NHK8815:
>
> stmpe-i2c 0-0043: stmpe2401 detected, chip id: 0x101
> nmk-i2c 101f8000.i2c0: write to slave 0x43 timed out
> nmk-i2c 101f8000.i2c0: no ack received after address transmission
> stmpe-i2c 0-0044: stmpe2401 detected, chip id: 0x101
> nmk-i2c 101f8000.i2c0: write to slave 0x44 timed out
> nmk-i2c 101f8000.i2c0: no ack received after address transmission
>
> It turns out that we start to poll for the reset bit to
> go low again too quickly: the STMPE2401 is not yet online and
> ready to be asked for the status of the RESET bit.
>
> By introducing a 10ms delay before starting to hammer
> the register for information, we get back to normal:
>
> stmpe-i2c 0-0043: stmpe2401 detected, chip id: 0x101
> stmpe-i2c 0-0044: stmpe2401 detected, chip id: 0x101
>
> Cc: [email protected]
> Cc: Patrice Chotard <[email protected]>
> Cc: Amelie Delaunay <[email protected]>
> Cc: Lee Jones <[email protected]>
> Fixes: c4dd1ba355aa ("mfd: stmpe: Add reset support for all STMPE variant")
> Signed-off-by: Linus Walleij <[email protected]>
> ---
> drivers/mfd/stmpe.c | 2 ++
> 1 file changed, 2 insertions(+)
Applied to -fixes.
> diff --git a/drivers/mfd/stmpe.c b/drivers/mfd/stmpe.c
> index cfdae8a3d779..b0c7bcdaf5df 100644
> --- a/drivers/mfd/stmpe.c
> +++ b/drivers/mfd/stmpe.c
> @@ -851,6 +851,8 @@ static int stmpe_reset(struct stmpe *stmpe)
> if (ret < 0)
> return ret;
>
> + msleep(10);
> +
> timeout = jiffies + msecs_to_jiffies(100);
> while (time_before(jiffies, timeout)) {
> ret = __stmpe_reg_read(stmpe, stmpe->regs[STMPE_IDX_SYS_CTRL]);
--
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog
