From: Yaniv Gardi <yga...@codeaurora.org>
The condition in which error message is printed out was incorrect and
resulted error message only if retries exhausted.
But retries happens only if DME command is a peer command, and thus
DME commands which are not peer commands and fail are not printed out.
This change fixes this issue.
Signed-off-by: Yaniv Gardi <yga...@codeaurora.org>
Signed-off-by: Subhash Jadavani <subha...@codeaurora.org>
---
drivers/scsi/ufs/ufshcd.c | 11 ++++++-----
1 file changed, 6 insertions(+), 5 deletions(-)
diff --git a/drivers/scsi/ufs/ufshcd.c b/drivers/scsi/ufs/ufshcd.c
index ec4c99a..b826078 100644
--- a/drivers/scsi/ufs/ufshcd.c
+++ b/drivers/scsi/ufs/ufshcd.c
@@ -2516,10 +2516,10 @@ int ufshcd_dme_set_attr(struct ufs_hba *hba, u32
attr_sel,
set, UIC_GET_ATTR_ID(attr_sel), mib_val, ret);
} while (ret && peer && --retries);
- if (!retries)
+ if (ret)
dev_err(hba->dev, "%s: attr-id 0x%x val 0x%x failed %d
retries\n",
- set, UIC_GET_ATTR_ID(attr_sel), mib_val,
- retries);
+ set, UIC_GET_ATTR_ID(attr_sel), mib_val,
+ UFS_UIC_COMMAND_RETRIES - retries);
return ret;
}
@@ -2583,9 +2583,10 @@ int ufshcd_dme_get_attr(struct ufs_hba *hba, u32
attr_sel,
get, UIC_GET_ATTR_ID(attr_sel), ret);
} while (ret && peer && --retries);
- if (!retries)
+ if (ret)
dev_err(hba->dev, "%s: attr-id 0x%x failed %d retries\n",
- get, UIC_GET_ATTR_ID(attr_sel), retries);
+ get, UIC_GET_ATTR_ID(attr_sel),
+ UFS_UIC_COMMAND_RETRIES - retries);
if (mib_val && !ret)
*mib_val = uic_cmd.argument3;
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project
