[PATCH 1/3] pinctrl: sx150x: use correct registers for reg_sense (sx1502 and sx1508)

[Peter Rosin]

All other registers on these chips are 8-bit, but reg_sense is 16-bits
and therefore needs to be moved down one notch.
This was apparently overlooked in the conversion to regmap, which only
updated the register locations for the 16-bit chips.

Fixes: 6489677f86c3 ("pinctrl-sx150x: Replace sx150x_*_cfg by means of regmap 
API")
Signed-off-by: Peter Rosin <p...@axentia.se>
---
 drivers/pinctrl/pinctrl-sx150x.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/pinctrl/pinctrl-sx150x.c b/drivers/pinctrl/pinctrl-sx150x.c
index f9e559e22537..a19c814843aa 100644
--- a/drivers/pinctrl/pinctrl-sx150x.c
+++ b/drivers/pinctrl/pinctrl-sx150x.c
@@ -156,7 +156,7 @@ static const struct sx150x_device_data sx1508q_device_data 
= {
        .reg_data       = 0x08,
        .reg_irq_mask   = 0x09,
        .reg_irq_src    = 0x0c,
-       .reg_sense      = 0x0b,
+       .reg_sense      = 0x0a,
        .pri.x789 = {
                .reg_drain      = 0x05,
                .reg_polarity   = 0x06,
@@ -221,7 +221,7 @@ static const struct sx150x_device_data sx1502q_device_data 
= {
        .reg_data       = 0x00,
        .reg_irq_mask   = 0x05,
        .reg_irq_src    = 0x08,
-       .reg_sense      = 0x07,
+       .reg_sense      = 0x06,
        .pri.x123 = {
                .reg_pld_mode   = 0x10,
                .reg_pld_table0 = 0x11,
-- 
2.1.4