On 4/5/17 11:35 AM, Randy Dunlap wrote:
On 04/04/17 19:06, Christopher Bostic wrote:
From: Chris Bostic <[email protected]>
Create a simple SCOM engine device driver that reads and writes
its control registers via an FSI bus.
Includes changes from Edward A. James <[email protected]>.
Signed-off-by: Chris Bostic <[email protected]>
Signed-off-by: Joel Stanley <[email protected]>
Signed-off-by: Edward A. James <[email protected]>
Signed-off-by: Jeremy Kerr <[email protected]>
---
drivers/fsi/Kconfig | 6 ++
drivers/fsi/Makefile | 1 +
drivers/fsi/fsi-scom.c | 263 +++++++++++++++++++++++++++++++++++++++++++++++++
3 files changed, 270 insertions(+)
create mode 100644 drivers/fsi/fsi-scom.c
diff --git a/drivers/fsi/Kconfig b/drivers/fsi/Kconfig
index 9cf8345..0fa265c 100644
--- a/drivers/fsi/Kconfig
+++ b/drivers/fsi/Kconfig
@@ -18,6 +18,12 @@ config FSI_MASTER_GPIO
---help---
This option enables a FSI master driver using GPIO lines.
+config FSI_SCOM
+ tristate "SCOM FSI client device driver"
+ depends on FSI
depends on FSI is redundant.
Will correct.
Thanks,
Chris
+ ---help---
+ This option enables an FSI based SCOM device driver.
+
endif
