Hi Mike, On Tue, May 09, 2017 at 07:36:30AM +0200, Mike Looijmans wrote: > This adds the devicetree bindings documentation for the LTC3651 battery > charger. > > Signed-off-by: Mike Looijmans <[email protected]>
Thanks, queued.
-- Sebastian
> ---
> v2: Add "lltc," vendor prefix to gpios
> Expand irq paragraph
>
> .../bindings/power/supply/ltc3651-charger.txt | 27
> ++++++++++++++++++++++
> 1 file changed, 27 insertions(+)
> create mode 100644
> Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt
>
> diff --git
> a/Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt
> b/Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt
> new file mode 100644
> index 0000000..71f2840
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt
> @@ -0,0 +1,27 @@
> +ltc3651-charger
> +
> +Required properties:
> + - compatible: "lltc,ltc3651-charger"
> + - lltc,acpr-gpios: Connect to ACPR output. See remark below.
> +
> +Optional properties:
> + - lltc,fault-gpios: Connect to FAULT output. See remark below.
> + - lltc,chrg-gpios: Connect to CHRG output. See remark below.
> +
> +The ltc3651 outputs are open-drain type and active low. The driver assumes
> the
> +GPIO reports "active" when the output is asserted, so if the pins have been
> +connected directly, the GPIO flags should be set to active low also.
> +
> +The driver will attempt to aquire interrupts for all GPIOs to detect changes
> in
> +line state. If the system is not capabale of providing interrupts, the driver
> +cannot report changes and userspace will need to periodically read the sysfs
> +attributes to detect changes.
> +
> +Example:
> +
> + charger: battery-charger {
> + compatible = "lltc,ltc3651-charger";
> + lltc,acpr-gpios = <&gpio0 68 GPIO_ACTIVE_LOW>;
> + lltc,fault-gpios = <&gpio0 64 GPIO_ACTIVE_LOW>;
> + lltc,chrg-gpios = <&gpio0 63 GPIO_ACTIVE_LOW>;
> + };
> --
> 1.9.1
>
signature.asc
Description: PGP signature
