Hi Marcin, On mar., mai 16 2017, Marcin Wojtas <[email protected]> wrote:
> Armada 8040 DB is equipped with 4 (2x 10G SFI + 2x 1G RGMII) > ethernet ports of which only one was hitherto enabled. > Because currently mvpp2 driver is capable of supporting only > 1G RGMII/SGMII, enable second port from CP slave HW block. > Applied on mvebu/dt64 Thanks, Gregory > Signed-off-by: Marcin Wojtas <[email protected]> > --- > arch/arm64/boot/dts/marvell/armada-8040-db.dts | 16 ++++++++++++++++ > 1 file changed, 16 insertions(+) > > diff --git a/arch/arm64/boot/dts/marvell/armada-8040-db.dts > b/arch/arm64/boot/dts/marvell/armada-8040-db.dts > index dc0d084..3cde649 100644 > --- a/arch/arm64/boot/dts/marvell/armada-8040-db.dts > +++ b/arch/arm64/boot/dts/marvell/armada-8040-db.dts > @@ -169,6 +169,22 @@ > status = "okay"; > }; > > +&cps_mdio { > + phy0: ethernet-phy@0 { > + reg = <0>; > + }; > +}; > + > +&cps_ethernet { > + status = "okay"; > +}; > + > +&cps_eth1 { > + status = "okay"; > + phy = <&phy0>; > + phy-mode = "rgmii-id"; > +}; > + > &ap_sdhci0 { > status = "okay"; > bus-width = <4>; > -- > 1.8.3.1 > -- Gregory Clement, Free Electrons Kernel, drivers, real-time and embedded Linux development, consulting, training and support. http://free-electrons.com
