On Tue, Jun 13, 2017 at 03:38:18PM -0500, Christopher Bostic wrote:
> Reference the system device tree when configuring the watchdog.
> Configure for external signal generation if optional attribute
> 'external-signal' is present in device tree. Configure for
> reset system after timeout if the optional attribute
> 'no-system-reset' is not present. Disabling system reset may be
> required in situations where one of the other watchdogs in the
> systems is responsible for this.
>
> Signed-off-by: Christopher Bostic <cbos...@linux.vnet.ibm.com>
> ---
> drivers/watchdog/aspeed_wdt.c | 13 +++++++++++--
> 1 file changed, 11 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/watchdog/aspeed_wdt.c b/drivers/watchdog/aspeed_wdt.c
> index 1c65258..9deb4be 100644
> --- a/drivers/watchdog/aspeed_wdt.c
> +++ b/drivers/watchdog/aspeed_wdt.c
> @@ -140,6 +140,7 @@ static int aspeed_wdt_probe(struct platform_device *pdev)
> {
> struct aspeed_wdt *wdt;
> struct resource *res;
> + struct device_node *np;
> int ret;
>
> wdt = devm_kzalloc(&pdev->dev, sizeof(*wdt), GFP_KERNEL);
> @@ -170,8 +171,16 @@ static int aspeed_wdt_probe(struct platform_device *pdev)
> * the SOC and not the full chip
> */
> wdt->ctrl = WDT_CTRL_RESET_MODE_SOC |
> - WDT_CTRL_1MHZ_CLK |
> - WDT_CTRL_RESET_SYSTEM;
> + WDT_CTRL_1MHZ_CLK;
> +
> + np = pdev->dev.of_node;
> + if (np && !of_get_property(np, "no-system-reset", NULL))
> + wdt->ctrl |= WDT_CTRL_RESET_SYSTEM;
> +
Please use of_property_read_bool(). Also, checking np for NULL is unnecessary
since the called function does that. Note that the above code as written is
wrong - if np is NULL, WDT_CTRL_RESET_SYSTEM will no longer be set.
The new properties should probably start with "aspeed," but I'll leave that
up to DT maintainers to decide.
> + if (np && of_get_property(np, "external-signal", NULL))
> + wdt->ctrl |= WDT_CTRL_WDT_EXT;
> +
> + writel(wdt->ctrl, wdt->base + WDT_CTRL);
>
> if (readl(wdt->base + WDT_CTRL) & WDT_CTRL_ENABLE) {
> aspeed_wdt_start(&wdt->wdd);
