2017-07-21 20:21 GMT+09:00 Kunihiko Hayashi <hayashi.kunih...@socionext.com>: > This series adds support for CPU temperature monitor modules implemented > on UniPhier LD20 and PXs2 SoCs. This driver supports temperature monitoring > and alert function on the module. > > Changes in v4: > - fix warnings from sparse by replacing u32 with __be32
Nit. Your subject prefix indicates this patch is v5. Do you mean "Changes in v5" or "Changes since v4" ? > Changes in v3: > - remove TMOD_MASK and use TMOD_WIDTH representing the bit width of TMOD > > Changes in v2: > - add nsleep after starting and stopping PVT > - replace temperature calculation with sign_extend32() > > Changes in v1: > - separate dts from this patchset as another patchset > - remove 'reg' description on the dt-bindings document > - fix the order of calling initialization functions > - replace mask bits to use GENMASK > - fix calculation of temperature because of not considering a negative value > - use devm_request_threaded_irq() instead of devm_request_irq() and > separate a thread function from the interrupt handler > - add dependency to Kconfig > - set 120C to CRITICAL_TEMP_LIMIT as maximum temperature > - shrink each line of parameters to save the number of lines > - improve some comments and copyright description > > Kunihiko Hayashi (2): > dt-bindings: thermal: add binding documentation for UniPhier thermal > monitor > thermal: uniphier: add UniPhier thermal driver > > .../bindings/thermal/uniphier-thermal.txt | 64 ++++ > drivers/thermal/Kconfig | 8 + > drivers/thermal/Makefile | 1 + > drivers/thermal/uniphier_thermal.c | 386 > +++++++++++++++++++++ > 4 files changed, 459 insertions(+) > create mode 100644 > Documentation/devicetree/bindings/thermal/uniphier-thermal.txt > create mode 100644 drivers/thermal/uniphier_thermal.c > > -- > 2.7.4 > -- Best Regards Masahiro Yamada