Hi David,

> This adds optional nvmem consumer properties to the ti,wlink-st device tree
> bindings to allow specifying the BD address.
> 
> Signed-off-by: David Lechner <da...@lechnology.com>
> ---
> 
> v2 changes:
> * Renamed "mac-address" to "bd-address"
> * Fixed typos in example
> * Specify byte order of "bd-address"
> 
> Documentation/devicetree/bindings/net/ti,wilink-st.txt | 5 +++++
> 1 file changed, 5 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/net/ti,wilink-st.txt 
> b/Documentation/devicetree/bindings/net/ti,wilink-st.txt
> index 1649c1f..a45a508 100644
> --- a/Documentation/devicetree/bindings/net/ti,wilink-st.txt
> +++ b/Documentation/devicetree/bindings/net/ti,wilink-st.txt
> @@ -32,6 +32,9 @@ Optional properties:
>    See ../clocks/clock-bindings.txt for details.
>  - clock-names : Must include the following entry:
>    "ext_clock" (External clock provided to the TI combo chip).
> + - nvmem-cells: phandle to nvmem data cell that contains a 6 byte BD address
> +   with the most significant byte first (big-endian).
> + - nvmem-cell-names: "bd-address" (required when nvmem-cells is specified)
> 
> Example:
> 
> @@ -43,5 +46,7 @@ Example:
>               enable-gpios = <&gpio1 7 GPIO_ACTIVE_HIGH>;
>               clocks = <&clk32k_wl18xx>;
>               clock-names = "ext_clock";
> +             nvmem-cells = <&bd_address>;
> +             nvmem-cell-names = "bd-address”;

For me this looks good, but I like to get an extra ACK from Rob on this.

Regards

Marcel

Reply via email to