Thanks for the review,
On 29/01/18 16:21, Rob Herring wrote:
On Tue, Jan 16, 2018 at 07:02:36PM +0000, srinivas.kandaga...@linaro.org wrote:
From: Srinivas Kandagatla <srinivas.kandaga...@linaro.org>
When Linux is master of BAM, it can directly read registers to know number
of supported execution enviroments, however when its remotely controlled
reading these registers would trigger a crash if the BAM is not yet
intialized/powered up on the remote side.
This patch adds new binding num-ees to specify supported number of
Execution Environments when BAM is remotely controlled.
Signed-off-by: Srinivas Kandagatla <srinivas.kandaga...@linaro.org>
---
Documentation/devicetree/bindings/dma/qcom_bam_dma.txt | 2 ++
drivers/dma/qcom/bam_dma.c | 15 ++++++++++++---
2 files changed, 14 insertions(+), 3 deletions(-)
The correct split is the binding changes in 1 patch. Driver changes
separate.
Sure, Will Split it in next version.
diff --git a/Documentation/devicetree/bindings/dma/qcom_bam_dma.txt
b/Documentation/devicetree/bindings/dma/qcom_bam_dma.txt
index aa6822cbb230..f0d10c2b393e 100644
--- a/Documentation/devicetree/bindings/dma/qcom_bam_dma.txt
+++ b/Documentation/devicetree/bindings/dma/qcom_bam_dma.txt
@@ -17,6 +17,8 @@ Required properties:
remote proccessor i.e. execution environment.
- num-channels : optional, indicates supported number of DMA channels in a
remotely controlled bam.
+- num-ees : optional, indicates supported number of Execution Environments in a
+ remotely controlled bam.
This one needs a vendor prefix as it is not a common property.
Make sense, I will change it in next version.
Thanks,
Srini
Example:
