On 2018-01-29 10:41, Sricharan R wrote:
Add the common parts for the dk04 boards.
Signed-off-by: Sricharan R <[email protected]>
---
arch/arm/boot/dts/qcom-ipq4019-ap.dk04.1.dtsi | 147
<snip>
+
+ nand_pins: nand_pins {
+ pullups {
+ pins = "gpio52", "gpio53",
"gpio58",
+ "gpio59";
+ function = "qpic";
+ bias-pull-up;
+ };
+
+ pulldowns {
+ pins = "gpio54", "gpio55",
"gpio56",
+ "gpio57", "gpio60",
"gpio61",
+ "gpio62", "gpio63",
"gpio64",
+ "gpio65", "gpio66",
"gpio67",
+ "gpio68", "gpio69";
+ function = "qpic";
+ bias-pull-down;
+ };
+ };
Can you please check once why do we need pull-up and
pull-down for NAND pins. The NAND chip will be mounted
over board itself so board design should take care of
required pull up and pull downs.
Also, some of the above pins like gpio52 will be only used
for LCD so we can remove those pins. Later on, when LCD
support will be added, we can add those pins.
Thanks,
Abhishek
