Hi Stefan,
On 03/08/2018 04:00 AM, Stefan Wahren wrote: > Hi Matheus, > >> Matheus Castello <math...@castello.eng.br> hat am 8. März 2018 um 01:12 >> geschrieben: >> >> >> Hi Stefan, >> >> On 03/07/2018 07:58 AM, Stefan Wahren wrote: >>> Hi Matheus, >>> >>>> Matheus Castello <math...@castello.eng.br> hat am 5. März 2018 um 03:29 >>>> geschrieben: >>>> >>>> >>>> Hi Linus and Stefan, >>>> >>>> thanks for the tips. >>>> >>>> This series adds support for generic binding for pinctrl bcm2835 driver, >>>> and add the code for set output buffer of a pin using the output-low and >>>> output-high generic properties. >>>> >>>> Tested on Raspberry Pi Zero W, based on bcm2835 SoC. >>>> >>>> Matheus Castello (3): >>> >>> looks like you missed the changes to the dt binding. Please also add Rob >>> Herring and Mark Rutland to CC. We need a ACK from them. >> >> are you talking about the .dts files? I add an overlay file for my tests. >> I was thinking it would be better to start with this changes in the driver >> and then in another series to convert to the generic style in the .dts. >> If you find it better already add the conversion also in this series let me >> know. >> >> I understood that I should put the device tree maintainers in thread only if >> I were to introduce a new property. As I am using generic properties and not >> introducing new ones I did not add them. >> Let me know if it is still necessary I stayed in this doubt. > > no this is a misunderstanding. You are changing the DT interface because the > driver supports new properties (from driver point of view). The DT users > usually look at the binding document [1] not the source code. So you need to > extend the binding document before changing the source code within a patch > series. At the end we need a DT maintainer's ACK for the binding change. > Using the generic properties doesn't allow us to skip this, but it increases > the chance of an ACK. > > Btw it's okay to keep the DTS files. > > Stefan > > [1] - > https://elixir.bootlin.com/linux/v4.16-rc4/source/Documentation/devicetree/bindings/pinctrl/brcm,bcm2835-gpio.txt > Ok, I got it, thank you, I will work on the patch v3. Best Regards Matheus Castello >> >> Best Regards >> Matheus Castello >>> >>>> pinctrl: bcm2835: switch to GENERIC_PINCONF >>>> pinctrl: bcm2835: Add support for generic pinctrl binding >>>> pinctrl: bcm2835: Add support for output-low output-high properties >>>> >>>> drivers/pinctrl/bcm/Kconfig | 1 + >>>> drivers/pinctrl/bcm/pinctrl-bcm2835.c | 88 >>>> +++++++++++++++++++++++------------ >>>> 2 files changed, 60 insertions(+), 29 deletions(-) >>>> >>>> -- >>>> 2.7.4 >>>>
